Filter
Top Products
12 - ENGLISH
www.boschappliances.com
If you have an SHI model, an integrated model, you will have additional mounting
hardware and a folded template sheet with installation instructions comprised of
pictograms. In North America the black, white and stainless steel models of the integrated
series (SHI series), have a control panel that is 5-5/16” (135 mm) tall. The black and
white models come with a standard extension piece, dimension “A” in Figure 21 and
Table 4, next page. The stainless steel model comes with two extension pieces, referred
to as the standard and long extension piece in Table 4: the standard piece is used for
drawer heights up to 6” (152mm); the long extension piece is used for drawer heights
greater than 6” (152mm) but 6-7/16” (164mm) or less. These stainless steel extension
pieces are not installed in the control panel. In the stainless steel models, the two
extension pieces are shipped loose and must be inserted as shown in pictogram 5 on the
template sheet.
The purpose of the extension piece is to allow the increase of the control panel height to
try to match the horizontal drawer line of the cabinets. If your drawers are taller than the
“C” dimension shown on Table 4, it is recommended that the extension either be slid in
as far as it will go, or removed and the door made to fit directly below the control panel.
Panel Installation, SHI Models
If you have an SHV model, a fully integrated model, you will have additional mounting
hardware and a folded template sheet with installation instructions comprised of
pictograms.
Refer to the folded template sheet for information on how to mount the panel. Please
note that one side of the template shows how to mount a one piece panel and the other
side of the template shows how to mount a two piece panel. Be sure of what type
installation you want before proceeding with the installation.
Refer to Figure 20 and Table 3 for guidelines on custom door panel selections.
After deciding if the extension pieces will be used or not refer to the pictograms printed
on the template for proper method of mounting your custom door.
Panel Installation, SHV Models
If you have an SHU model (other than the SHU 9910, 9920 or 9940 models) and have
ordered an accessory panel kit it must be installed prior to sliding the dishwasher into
place. Dimensions of panel size that may be used is shown in Figure 19.
Accessory Panel Installation SHU Models
DOOR PANEL INSTALLATION