Filter
Top Products
11
WARNING
You could be seriously scalded if you allow hot water to splash out of the dishwasher. OPEN THE DOOR CAREFULLY during any
wash or rinse cycle. Do not fully open the door until water noises have stopped.
To cancel cycle:
- Open door just far enough to expose the controls then press the “START RESET” button until the Active LED goes out.
- Close the door and wait about 1 minute or until you hear the buzzer (if active)
- Open the door and press “ON/OFF”
- Door must be open. Turn unit on.
- Wash cycle LED will be ashing to indicate pre-select mode.
- To enter setup mode press and hold
then press and release “START RESET” button; then release .
Active button will be ashing to indicate setup mode.
- Press
to select an option (Rinse Agent/ Extra dry heat/ Tone)
- Press
to adjust the settings for the respective options. (Press Start to save)
To set Rinse Agent amount: Active + Rinse Agent LED ashing. Follow steps under setting options above
NOTE: If your glasses have spots you need more Rinse Agent. If your glasses have streaks you need less Rinse Agent.
Power Scrub Regular
Wash
Quick Wash Rinse Aid Setting
0 (least)
1
2
3
4
5
6 (most)
To set Extra Dry Heat: Active + Sanitized LED ashing . Follow steps under setting options above
Power
Scrub
Regular
Wash
Quick
Wash
Extra dry
Heat
not activated
activated
To set Cycle Completion Signal: Active + Rinse Agent LED ashing. Follow steps under setting options above
Power
Scrub
Regular
Wash
Tone set-
ting
0
Low
Medium
High