Bosch Appliances SHU 3000 Dishwasher User Manual


 
After filling the detergent compartment close the cover
by sliding it over the detergent chamber and pressing
down on the button until it dicks shut. The detergent will
be dispensed automatically during the wash portion of the
cycle.
If the cover of the detergent dispenser is closing fully but
it won't latch this is most likely due to the dishwasher
having been stopped in mid cycle. Check the position of
the "Start and Run Knob", see Figure 2, to see if cycle has
been completed. If the cycle is not completed please refer
to section of this manual tiffed TO INTERRUPT OR
RESET CYCLE to reset cycle.
RINSE AGENT INDICATOR
There is level indicator on the dispenser, see Figure 11
and 13. This indicator shows the level of rinse agent that is
in the rinse agent reservoir. As received, and when empty,
the level indicator on the dispenser will appear blank.
When the rinse agent reservoir is full the level indicator on
the dispenser will appear dark.
H_12.
RINSE AGENT DISPENSER REGULATOR
The rinse agent reservoir of the Bosch dishwasher is
provided with a regulator calibrated from 1to 6. See
Figure 13. This regulator controls the amount of rinse
agent dispensed. The dishwasher leaves the factory
preset to 3½. This has been chosen as the average setting,
however:
if you see streaks, it is recommended that the regulator
be turned to a lower number.
if water spots appear, it is recommended that the
regulator be turned to a higher number.
Rinse agent level indicator
Figure 11.
IMPORTANT
Rinse agent, or a rinse aid, is used to diminish water
spotting and to provide optimum drying results. Rinse
agent must be used at all times with the Bosch
dishwasher.
RINSE AGENT DISPENSER
The rinse agent dispenser is locaw.d next to the detergent
dispenser. See figure 12. Rinse agent is available in liquid
or solid forrn..Do not use the solid type of rinse agent in
the Bosch dishwasher.
To fill the rinse agent reservoir (refer to Figure 12):
Open the dishwasher door fully.
Open the cover of the rinse agent dispenser.
Add rinse agent to the reservoir until the clear level
indicator turns completely dark. The reservoir is full
when the level indicator is dark.
Close the cover of the rinse agent dispenser. Make
sure that it is firmly snapped closed.
indicator
Dosage control
Figure 13.
TO ADJUST SETTING:
Open the cover of the rinse agent dispenser.
Turn the setting indicator to the desired setting. See
Figure 13.
Close the cover of the rinse agent dispenser. Make
sure that it is firmly snapped closed.
CYCLE SELECTION
The dishwasher will wash and dry the contents based on
cycle selection made. Refer to the CYCLE SELECTION
CHART, Table 2. The most appropriate cycle for the load
to be washed can be selected from this table by comparing
the load type and the amount and condition of the food on
the items to the charts recommendations.
9