Filter
Top Products
English
30
(Operate the Controls, Continued)
Top Control
1. Open the dishwasher door far enough to
expose the control buttons.
2. Press the On/Off button.
3. Press the button for wash cycle desired.
4. Close the dishwasher door and make
sure it is securely shut.
5. The dishwasher will start and automati-
cally continue operating until the end of
the selected cycle.
WARNING: YOU COULD BE SERI-
OUSLY SCALDED IF YOU OPEN THE
DISHWASHER DOOR QUICKLY DURING
A WASH OR RINSE CYCLE. ALWAYS
WAIT AT LEAST 10 SECONDS (OR
UNTIL WATER NOISES STOP) BEFORE
FULLY OPENING THE DISHWASHER
DOOR.
Once you start the dishwasher, leave the
dishwasher door shut until it finishes the
cycle. At the end of the cycle the
dishwasher will stop. Depending on the
model of dishwasher you have
• the “Clean” light will illumninate,
• the LED display will show “0”,
• the dishwasher will beep
• the “Sanitized” light will illuminate
When the “Sanitized” light illuminates, it
means that the wash cycle has met very
strict requirements of time and temperature
for certification as “Sanitized” by the
National Sanitation Foundation. For more
information on this certification, turn the
section titled “The NSF Symbol” on page 7
in this manual.
Interrupting, Changing, and Cancelling
Cycles
As a safety feature, the dishwasher will
automatically turn itself off whenever the
door is opened.
Interrupting a Cycle
Front Control
1. Press the On/Off button to stop
operation.
2. Wait at least 10 seconds (or until
water noises stop) before opening the
door.
3. To resume the cycle, close the
dishwasher door and push the On/Off
button
(Continued On Next Page)
Operation | Fonctionnement | Operación