Filter
Top Products
9
- To reinstall the top spray arm:
f
) Return the top spray arm to its
installed position.
g
) Return the locking nut to its
installed position and turn it 1/8 turn
clockwise.
h
) Return the top rack to the top rack
roller guides.
- To remove the bottom spray arm:
i
) Remove the empty bottom rack from
the dishwasher tub.
j
) Grasp and lift the bottom spray arm
as shown in Figure 19.
k
) Look for obstruction in the spray
nozzles.
l
) If the spray nozzles need cleaning,
flush them under running water.
- To reinstall the bottom spray arm:
m
) Return the bottom spray arm to its
installed position and press it so that it
snaps into place.
n
) Return the bottom rack to its
installed position.
5. Check/Clean the Filter System
Your Bosch dishwashers has a filter
system that is made up of a Large Object
Trap/Cylinder Filter assembly and a Fine
Filter. The filter system is located on the
dishwasher floor and is easily
accessible.
During normal use the filter system is
self-cleaning, but you should
occasionally inspect it for foreign objects
and clean it when necessary.
Figure 19
d
) Look for obstruction in the spray
nozzles.
e
) If the spray nozzles need cleaning,
flush them under running water.
INJURY HAZARD: The large object
trap could contain sharp objects. Do
not reach into the large object trap
with your fingers.
CAUTION
- To Remove the Large Object
Trap/Cylinder Filter Assembly:
a
) Remove the bottom rack.
b
) Grasp the assembly as shown in
Figure 20, and turn it counter-clockwise
1/4 turn.
c
) Lift out the assembly as shown in
Figure 21.
Figure 21
Figure 20
d
) Carefully examine the assembly. If
you find debris in the Large Object Trap,
turn it upside-down and gently tap it on
a surface such as a countertop to
dislodge and remove the debris. Flush
the Cylinder Filter clean by holding it
under running water.
- To Remove the Fine Filter:
e
) Lift the Fine Filter from the
dishwasher floor as shown in Figure 22
and flush it clean by holding it under
running water.
4. Check/Clean the Spray Arm
Nozzles
Occasionally check the spray arms to
ensure that the spray nozzles are
unobstructed. You must remove the spray
arms to check them for obstruction.
- To remove the top spray arm:
a
) Remove the empty top rack from the
dishwasher.
b
) Turn the rack upside-down. The top
spray arm is held in position by a locking
nut as shown in Figure 17A. Turn the
locking nut counter-clockwise 1/8 turn and
remove it, as shown in Figure 17B to
release the spray arm.
c
) Remove the spray arm as shown in
Figure 18.
Figure 17
A
B
Figure 18
Figure 22
CARE AND MAINTENANCE