Filter
Top Products
12 13
OPERATING YOUR BREVILLE PRODUCT
FILLING THE WATER TANK
• Ensure the water filter is securely fitted
inside the tank.
• Fill the water tank with cold tap water
to the maximum mark on the side of the
tank and slide the water tank back into
position at the back of the machine.
• Plug the power cord into power outlet
and switch On at power point.
• Press the POWER button. The POWER
button surround will flash while the
machine is heating. When the correct
temperature has been reached, all the
button surrounds on the control panel
will illuminate.
NOTE
Check the water level before use and
replace the water daily. The water
tank should be filled with fresh, cold
tap water before each use.
Do not use de-mineralised or distilled
water or any other liquid.
SETTING THE GRIND SIZE
The grind size will affect the rate of water
flow through the coffee in the filter basket
and the flavour of the espresso. When
setting the grind size, it should be fine but
not too fine and powdery.
There are 18 settings on the GRIND SIZE
select dial - The smaller the number, the
finer the grind size. The larger the number,
the coarser the grind size. We recommend
you start at the No. 5 setting and adjust
as required.
GRINDING THE COFFEE
• Fill the hopper with fresh coffee beans.
• Place the portafilter into the
grinding cradle.
• Insert filter basket required into the
porta-filter.
Press the FILTER SIZE button to select
your filter size (single or double).
SINGLE
FILTER SIZE
DOUBLE
AUTOMATIC DOSING
• Push and release the portafilter to
activate the grinding switch, then allow
the portafilter to be dosed with fresh
ground coffee.
• To stop the grinding function during
single or double dose, simply press the
filter size button.
OPERATING YOUR BREVILLE PRODUCT
ADJUSTING THE GRIND AMOUNT
Set the GRIND AMOUNT dial to the
3 o’clock position as a starting point for dose
amount. Adjust towards LESS or MORE as
required to adjust the dose amount so the cap
on the supplied tamper is level with the top
edge of the filter basket rim, AFTER tamping.
NOTE
You may need to adjust the GRIND
AMOUNT dial a few times to achieve
the correct grind amount.
MANUAL DOSING
• With the portafilter inserted, push and
hold the micro switch down until the
desired amount of ground coffee has
been dosed.
• To stop the function during a manual
grind function, simply release the
portafilter. This will release the activation
switch to stop the grind function.
TAMPING THE GROUND COFFEE
• Once the grind function has been
completed, carefully withdraw the
portafilter from the grinding cradle,
being careful not to spill any ground
coffee, tap down to collapse and using
the integrated tamper, tamp down firmly
(approx. 15–20 kg of pressure).
TRIMMING THE DOSE
The Razor™ precision dose trimming tool
allows you to trim the puck to the right level
for a consistent extraction.
the Razor
™
Precision dose trimming tool
Insert the Razor™ into the coffee basket
until the shoulders of the tool rest on the
rim of the filter basket. The blade of the
dosing tool should penetrate the surface
of the tamped coffee.
Rotate the Razor™ dosing tool back and forth
while holding the portafilter on an angle over
the knock box to trim off excess coffee.
Your coffee filter basket is now dosed with
the correct amount of coffee.