Filter
Top Products
11
12
Cleaning
Motor base
Always ensure the Wizz Chopper & Shaker is
switched off at the power outlet and the power
cord is unplugged from the power outlet before
cleaning.
Wipe the motor body with a clean damp cloth
after each use.
Other parts
Wash the processing bowl, processing lid,
shaker attachment and chopping blade
in warm to hot soapy water using a mild
detergent. Rinse and dry thoroughly.
The processing bowl, processing lid, chopping
blade and shaker attachment may also be
washed in the dishwasher (top shelf only).
Do not use steel wool, scouring pads or
abrasive cleaners, as these will scratch the
surfaces.
The chopping blade is very sharp so handle
with care at all times. Use extreme care
when washing. To avoid accidental cuts
do not leave the chopping blade to soak in
sudsy water.
Note
Food stains and odours
Food such as spices may leave a stain on
plastic parts whilst other foods such as garlic
will leave a strong odour. To remove either,
soak the parts for 5 minutes in 1 litre water
with ¼ cup lemon juice.
Storage
Before storing, thoroughly wash and dry all
parts.
Always ensure the Wizz Chopper & Shaker is
switched off at the power outlet and the power
cord is unplugged from the power outlet before
storing.
Store the Wizz Chopper & Shaker assembled,
with the chopping blade inserted in the bowl,
on the kitchen bench or in an easy to access
cupboard. Store the Wizz Chopper & Shaker
out of reach of children. Store the appliance
upright. Do not store anything on top of the
appliance.
The chopping blade is very sharp, use
extreme care when storing.
Note
Care, Cleaning & Storage
PROBLEM SOLUTION
Motor doesn’t start or chopping blade
doesn’t rotate
Check that the processing bowl, processing lid,
and motor body are assembled correctly and
securely in place. Check that the power plug
is securely inserted into the power outlet and
switched ‘ON’.
Food is unevenly chopped
Either too much food is being chopped at one
time or the pieces are not small enough. Try
cutting food into smaller pieces of even size and
processing a smaller amount per batch. For best
results the food should be chopped into pieces no
larger than 2cm.
Food is chopped too fine
The food is over processed. Next time use brief
pulses or process for a shorter time.
Food collects under the processing lid or
around sides of processing bowl
Processing too much food. Turn the Wizz Chopper
& Shaker off at the power outlet. When the
chopping blade stops rotating, remove the motor
body and processing lid. Clean the processing
bowl and processing lid with a spatula. Reduce
quantity of food to be processed.
Food sticks to chopping blade
Processing too much food. Turn the Wizz Chopper
& Shaker off at the power outlet. When the
chopping blade stops rotating, remove the motor
body and processing lid. Carefully remove the
blade. Remove the food from the chopping blade
with a spatula. Reduce quantity of food and
continue processing.
Troubleshooting table
Troubleshooting
CAUTION: NEVER IMMERSE THE MOTOR BODY, POWER CORD OR POWER PLUG IN
WATER OR ANY OTHER LIQUID. DO NOT PLACE THE MOTOR BODY IN THE DISHWASHER.