Filter
Top Products
15
OPERATING YOUR BREVILLE VARIABLE TEMPERATURE KETTLE™
Before First Use
Remove and safely discard any packaging
material or promotional labels attached to
your kettle. It is recommended that before
first use to fill the kettle to the maximum
level with cold tap water, bring to the boil
by selecting the BOIL 212° button, then
discard the water. Your kettle will only
operate when positioned on the power
base. The kettle will automatically switch
off when the water has reached the
selected temperature.
Operation Of Your Kettle
To fill the kettle, remove the kettle from 1.
the power base and open the lid by
pressing the lid release button. Fill with
the desired amount of water. Always fill
the kettle between the minimum (500)
and maximum (MAX 1800) marks on
the water window. Too little water will
result in the kettle switching off before
the water has boiled or reached the
selected temperature.
Ensure the lid is closed and locked 2.
firmly into place. Position the kettle
securely onto the power base. Insert
the power plug into a 110/120V power
outlet. The START/CANCEL and 212°
BOIL button surrounds will illuminate in
white for one minute. A beep will sound
for two seconds. The START/CANCEL
button surround will automatically switch
off after one minute if not selected.
NOTE:
If the START/CANCEL button is pressed
(before selecting a temperature button),
the START /CANCEL button surround
will illuminate in red and the 212º button
surround will illuminate in white and the
kettle will start heating.
Select the desired water temperature 3.
by pressing one of the five variable
temperature buttons (175˚, 185˚, 195˚,
200˚, 212˚). The selected button and the
START/ CANCEL button surround will
illuminate in white.
NOTE:
The HOLD TEMP function can be selected
before, during or on completion of the
water heating cycle (refer page 9).
Press the START/CANCEL button and 4.
the surround will illuminate in red, the
selected temperature button surround
will illuminate in white and the kettle will
start heating. Do not remove the kettle
from the power base during operation.
Ensure the kettle has switched off after
the water has boiled or the selected
temperature has been reached before
removing the kettle from the power
base. If the kettle is removed from the
power base during the HOLD TEMP
function the kettle will automatically
switch off.
When the kettle has heated the water 5.
to the selected temperature, 3 beeps
will sound, the START/CANCEL button
surround illumination will switch off,
and the selected temperature button
surround will illuminate for 1 minute
before switching off.
If the HOLD TEMP function has been 6.
selected, the HOLD TEMP button
surround will remain illuminated in
red, the selected temperature button
surround will remain illuminated in white,
and the kettle will continue to cycle on
and off for 20 minutes.
If further heating of the kettle is not 7.
required, unplug the power cord and
empty the water from the kettle.
Replace the kettle onto the power base
and close the lid.