Filter
Top Products
63
TROUBLESHOOTING
PROBLEM EASY SOLUTION
EO is displayed on
LED Screen
a. Check that lid is closed properly.
b. Check that the Pressure Release Valve is in the
correct position.
c. Make sure the silicone rubber gasket is attached
properly to the gasket holder and is securely in place
on the lid.
E1 is displayed on
LED Screen
• Unplug unit and allow to sit for 20 minutes. If no
change, Please call Breville Consumer Service.
E2 is displayed on
LED Screen
• Ensure the cooking bowl is properly positioned
inside base. The cooking bowl must be in direct
contact with the heating plate. Make sure there are
no unwanted materials on the heating plate.
E3 is displayed on
LED Screen
• Ensure the lid is off the appliance or placed on top
to rest in an offset position when you are using the
SAUTÉ/SEAR setting.
The appliance automatically
switches to Keep Warm
without going through a
complete cooking cycle
• Add more water to cooking bowl and restart the
cooking cycle.
Air is escaping from the rim
of the lid
a. Install sealing gasket correctly.
b. Clean sealing gasket.
c. Replace sealing gasket.
d. Lock lid again.
Steam is released from the
pressure indicator valve
during cooking
a. Clean sealing gasket.
b. Replace sealing gasket.
c. Change silicone rubber gasket every 1–2 years.
The pressure indicator rod
does not rise in PRESSURE
COOK setting
a. Place Pressure release valve in the correct position.
b. Place more food and water in the cooking bowl.
c. Call Breville Consumer Service.
Lid is hard to open or cannot
be opened
a. Check if the pressure indicator locking pin is in the
upright position. If it isn't, push down with aid of a
pencil or like item, jiggle the lid and disengage. This
will allow the air to escape and the lid should open.
BPR600XL_IB_B13.indd 63 18/01/13 1:03 PM