Filter
Top Products
COOL ZONE TECHNOLOGY
The submerged heating element system on
this deep fryer allows oil to be heated more
effectively where the food is cooked.
Oil below the heating element is cooler
and allows cooked foods including crumbs to
sink to the bottom of the enamel bowl and
not cook any further.
This allows cleaner oil to be removed
from the bowl for re-use without the
inclusion of food particles.
The Cool Zone Technology results
in a lesser need to change cooking oil. Used
oil can be re-used more than in standard
deep fryers.
AUTO CUT-OUT AND
RESET BUTTON
Always add the required amount of oil
BEFORE switching the power on at the
power outlet. An Auto cut out safety switch
will be activated if the unit is turned on
without oil in the bowl.
To re-activate the unit, let the unit cool
and then reset by pushing the button on the
controller assembly.
OPERATING YOUR BREVILLE DEEP FRYER cont’d CARE AND CLEANING
10
••
Before cleaning the deep fryer, always
make sure the unit is switched off then
disconnected from the power outlet.
••
Make sure the unit and oil are completely
cool. Do not attempt to move or carry the
deep fryer while it is hot.
••
Wash the basket in hot soapy water.
Dry thoroughly.
••
Remove the front panel of the deep fryer
by lifting upwards (see fig 1).
••
Grasp each side of the removable bowl
and lift upwards (see fig 2).
••
Empty the bowl of cooled oil. As oil can
be re-used several times (depending on
type of food cooked), filter the oil through
a fine sieve (such as a new chux cloth).
••
The removable enamel bowl allows for
easy cleaning. Wipe down the bowl with
absorbent paper, then a damp cloth and a
little mild detergent. Finally wipe the
bowl with a clean damp cloth and dry
with a clean dry cloth.
••
Wipe over the front panel and element
with a damp cloth and a little mild
detergent. Finish off with a clean damp
cloth followed by a clean dry cloth.
••
The removable bowl and frying basket
and both dishwasher safe.
••
Wipe over the outside of the unit with a
damp cloth and a little mild detergent.
Finish off with a clean damp cloth
followed by a clean dry cloth.
••
Reassemble unit for storage.
11
DO NOT UNDER ANY CIRCUMSTANCES IMMERSE THE CONTROL
ASSEMBLY OF THE DEEP FRYER, THE SUPPLY CORD OR PLUG IN WATER
OR ANY OTHER LIQUID.
ALWAYS TURN THE APPLIANCE OFF, THEN TURN THE POWER OFF AT
THE POWER OUTLET AND THEN UNPLUG CORD BEFORE ATTEMPTING TO
MOVE THE APPLIANCE AND BEFORE CLEANING.
Fig. 1
Fig. 2
BR4345 DFY25 Instruction Book 13/1/04 5:34 PM Page 10