Broan E66136SS Range User Manual


 
- 12 -
Reinstall grease drip rail. The illustration beside shows how to reinsert the grease
drip rail into the range hood.
17. REINSTALL GREASE DRIP RAIL AND BAFFLE FILTERS
HD0244
NOTE:Assemble the metal handles
to the filters, using provided
no. 8-32 x 1/4” screws, before
installing them in the hood.
It is recommended to install side
filters first and finish with center one(s).
1. Insert one end of the filter into the
upper channel of the hood.
2. Raise the other end toward the
inside of hood and insert in the
grease drip rail of the hood.
CAUTION
Remove protective plastic film covering filters before installing them.
1
HD0245
2
18. INSTALL LIGHT BULBS
This hood must use 50W, 120V with GU10 base, shielded halogen bulbs (not
included). (2 required for 30” and 36” hood width or 3 for 42” and 48” hood width.)
WARNING
In order to prevent the risk of personal injury, the halogen bulbs must be cooled down before removing
them.
!
1. Install bulbs by placing the bulb leads into their grooves in the socket.
2. Gently push upwards and turn clockwise until secure.
To remove bulbs, gently push upwards and turn counterclockwise to disengage bulb leads from their grooves.
NOTE: If need be, use a rubber dishwashing glove to add grip when removing the bulb.
12
HO0090
16. INSTALL THE BLOWER (EXTERIOR OR IN-LINE BLOWER)
Refer to instructions included with blower.
Plug the 3-prong plug cord from rough-in plate to the 3-prong male
connector inside the hood (A) and the 2-prong male connector cord from rough-in
plate to the 2-prong plug inside the hood (B).
HE0078
WARNING
Do not plug the 2 cords together.
!
A
B
WARNING
In order to prevent the risk of personal injury, do not install a
lamp identified for use only in enclosed fixtures.
!