Bunn 2SH Beverage Dispenser User Manual


 
Page 3
00986.0000
28342.1 071912
USER NOTICES
Carefully read and follow all notices on the equipment and in this manual. They were written for your protec-
tion. All notices are to be kept in good condition. Replace any unreadable or damaged labels.
ELECTRICAL REQUIREMENTS
The stands have an attached cordset and requires 2-wire grounded service rated 100V or 120 volts ac, single
phase, 90 watts total for the 1SH, 180 watts total for the 2SH, or 2-wire grounded service rated 220-240 volts
ac, single phase, 90 watts total for the 1SH, 180 watts total for the 2SH.
WARNING - The unit must be disconnected from the power source until specified in Initial Set-Up.
Refer to Data Plate on the Housing, and local/national electrical codes to determine circuit requirements.
220-240 volt ac Models
Note: This electrical service consists of 2
current carrying conductors (L1 and L2)
and a separate conductor for earth ground.
GREEN GREEN
N
L1
N
L1
RED
BLK
BLU
BRN
230V
\YELLOW