Filter
Top Products
3
3. Increasing / Decreasing the Hopper Dispense Rate:
a. Enter the program mode on the position you want to program (see step 1.a.)
b. Place the Rinse/Run switch in the “Rinse” position.
c. Press and hold down on the stop switch and press the “S” switch to decrease the dispense rate or press the
“XL” switch to increase the dispense rate. Each time the button is pressed, the dispense rate will increase/
decrease by approximately 2
1
/
2
%. Each time the “S” or “XL” switch is pressed, the L.E.D. on that position will
flash on and off to indicate the switch was recognized. When the maximum or minimum level is reached all
3 position L.E.D.’s will flash rapidly.
d. To return the dispense rate to the factory preset, press and hold down stop switch and press either the “M”
or “L” switch. When the switch is pressed, the L.E.D. on that position will flash on and off to indicate the switch
was recognized.
e. Return the Rinse/Run switch to the “Run” position.
f. Exit the programming mode (see step 1.b.)
4.
Making Common Timed Dispenses: Once a position has been programmed to the proper dispense times, you
can make all 3 positions the same, as follows:
a. Place the Rinse/Run switch in the “Run” position.
b. Enter the program mode on the position you want all others to be like (see step 1.a.)
c. Press and hold the Stop switch for 10 seconds.
d. After the 10 second period, all 3 position L.E.D.’s will come on solid indicating the task is complete. The
program mode is exited when the Stop switch is released.
5.
Running Hopper Throw Test: The hopper throw can be checked by automatically running the hopper motor
as follows:
a. Remove the steam collector and mixing chamber from under the hopper to be checked.
b. Position a small cup under the hopper outlet.
c. Enter the program mode on the position you want to check (see step 1.a.)
d. Place the Rinse/Run switch in the “Run” position.
e. To select a mocha dispense, momentarily press the “MOCHA” switch at the appropriate position. Note that the
“MOCHA” LED lights when mocha is selected. For non-mocha dispenses, skip to step 5.f.
f. Press and hold the stop switch down and press the appropriate cup size switch. The hopper will run for the
programmed timed dispense period at the programmed dispense rate.
g. Remove the cup and weigh the dispensed product.
h. Exit the programming mode (see step 1.b.)
i. Replace the mixing chamber and steam collector.
6. Making Common Dispense Rates: Once a position has been programmed to the proper hopper dispense rate,
you can make all 3 positions approximately the same, as follows:
a. Place the Rinse/Run switch in the “Rinse” position.
b. Enter the program mode on the position you want all others to be like (see step 1.a.)
c. Press and hold the Stop switch for 10 seconds.
d. After the 10 second period, all 3 position L.E.D.’s will come on solid indicating the task is complete. The
program mode is exited when the Stop switch is released.
e. Return the Rinse/Run switch to the “Run” position.
29215 101599