Bunn FMDS-3 Beverage Dispenser User Manual


 
BUNN
®
practices continuous product research and improvement. We reserve the right to change specifications and product design without notice. Such
revisions do not entitle the buyer to corresponding changes, improvements, additions or replacements for previously purchased equipment.
All dimensions shown in inches. Bunn Corporation owns all copyrights relating to materials in this publication. Please contact Bunn Corporation to request permission to reproduce any portion of this publication.
Dimensions & Specifications
BUNN Corporation - 1400 Stevenson Drive Springfield, Illinois 62703 • 800-637-8606 • 217-529-6601 • Fax 217-529-6644 • www.bunn.com
Model Product # Volts Amps Tank Heater Total Capacity Cu. Shipping Cord
Watts Watts Ft. Weight Attached
FMD-3 BLK SET00.0197 120 15 1700 1800 5.2 gal./hr.** 8.1
ft
3
86 lbs. Yes*
FMD-3 BLK
ƒ
SET00.0332 120 15 1700 1800 5.2 gal./hr.** 8.1 ft
3
86 lbs. Yes*
FMD-3 SS SET00.0198 120 15 1700 1800 5.2 gal./hr.** 8.1
ft
3
86 lbs. Yes*
FMDS-3 BLK
28600.0000 120 15 1700 1800 5.2 gal./hr.** 8.1 ft
3
84 lbs. Yes*
FMD DBC-3 BLK 29250.0000 120 15 1700 1800 5.2 gal./hr.** 8.1
ft
3
85 lbs. Yes*
Model has soup dispense tips and graphic. *Power cord (NEMA 5-15P) 15 Amp-120V machine only. **Based on incoming water temperature of 60ºF.
ƒ
Cafe display.
Door Conversion Kit—From model HC (black decor only) to model FMD door - 28613.0000
Note: SS=stainless steel cabinet with black door, BLK=black decor.
Electrical: 120V model requires 2-wires plus ground service rated 120V, single phase, 60 hz. 120/240V model requires
3-wires plus ground service rated 120/208 or 120/240V, single phase, 60Hz.
Plumbing: 20-90 psi (138-621 kPa) from a
3
8
" or larger supply line. A shut-off valve should be installed in the line
before the unit. Install a regulator in line when pressure is greater than 90 psi to reduce it to 50 psi. Supplied
with
1
4
" male flare fitting.