Filter
Top Products
7
BREWING DELICIOUS COFFEE
Insert a BUNN
®
coffee filter into the brew funnel.
Be sure to use BUNN
®
coffee filters for proper
brewing. Order more paper filters direct from
BUNN
®
at www.bunn.com
Measure coffee into the filter and gently shake the
filter to level the bed of grounds. To determine the
amount of coffee to be used, see Page 8.
Make sure that the sprayhead is tight. Slide the brew
funnel into the brewer under the warmer switch. Place
the lighted warmer switch in the “ON” position.
Raise the hinged flip-lid and pour a decanter of water
into the top of the brewer. Place the decanter on the
warmer, THEN close the lid. Your BUNN
®
brewer will
begin brewing coffee immediately. Flip-lid should also
remain closed when brewer is not in operation.
P206
P205
P2241
P2247
P215
When brewing has stopped, remove the brew funnel
and discard the filter and grounds. Do not touch hot
grounds.
NOTE: Opening the lid during brew cycle will interrupt the flow of water into the tank,
but will not interrupt the brewing process. The brewed coffee already in the funnel
will empty into the decanter. When lid is closed, the flow of water into the funnel will
resume until the brewing cycle is complete.
WARNING:
Do not close the lid after pouring in water, without the decanter in place.
Closing the lid releases the hot water.
HOT WATER (USE WITH CAUTION)
The same basic steps can be used to obtain hot water by omitting the filter and coffee.
The water from your BUNN
®
coffee brewer is approximately 200° F. This is hotter
than the hot water from your faucet and must be handled with care.
Step 1
Step 2
Step 3
Step 4
Step 5
O
F
F
O
N
B
U
N
N
6
4
8
10
O
N
W
A
R
M
E
R
B
U
N
N
O
F
F
B
U
N
N
6
4
8
1
0