Filter
Top Products
Page 9
READY TO BREW
WATER TEMP XXX°
CARD CONTAINS
RECIPE FOR
(RECIPE NAME)
SHOW QUIT SAVE
(RECIPE NAME)
NOT SAVED
(RECIPE NAME)
SETUP COMPLETE
READY TO BREW
WATER TEMP 200°
5 SEC.
POSITION CARD UNDER
SENSOR COIL
SCROLLS THROUGH
ALL BREW SETTINGS
FOR THAT RECIPE
PROGRAMMING WITH RECIPE CARD
Using a RECIPE CARD to load recipes:
The RECIPE CARD includes all the information needed
to set up that particular coffee/tea name. The informa-
tion from the RECIPE CARD is loaded into the brewer’s
memory by holding the chip area up to the brewer’s
SENSING COIL. This information can include all the
recipe settings for that particular name. These can all
be loaded in seconds.
NOTE: Instructions to program the brewer and grinder
are printed on the RECIPE CARD, along with the coffee
name that is being programmed.
Procedure to program the coffee name:
1. Remove the funnel(s) if present.
2. Position the RECIPE CARD vertically, so that the
top end of the CHIP is beneath the (Left on Twins)
SENSING COIL (located on the underneath side of
the front display panel).
3. After a short pause the display will read CARD
CONTAINS RECIPE FOR then will change to (RECIPE
NAME) SHOW-QUIT-SAVE. All brewing parameters
for that recipe are now transferred from the CARD
to the brewer.
4. To show (view) this information, press and release
SHOW. The display will scroll through all of the
brew settings for that recipe. This display will then
return to CARD CONTAINS RECIPE FOR then will
change to (RECIPE NAME) SHOW-QUIT-SAVE.
5. If all brew settings are correct, press SAVE. The dis-
play will read (RECIPE NAME) SETUP COMPLETE.
All brew settings for that name are now stored in
the brewer’s memory.
6. If the brewing information is not correct, or it is
desired to exit the setup before the settings are
loaded into the brewer’s memory, press QUIT. The
display will read (RECIPE NAME) NOT SAVED. The
display will then return to the MAIN SCREEN.
41581.2 091609
NOT AVAILABLE ON ITB