Filter
Top Products
9
OPERATING CONTROLS
FIG 7 Refrigeration Switch - JDF-2S
FIG 9 Product Dispense Switches - JDF-2S
DISPENSER USE
Press and Hold Dispensing:
1. Place a cup on the drip tray beneath the desired dispensing nozzle.
2. Press and hold the “Product Dispense” switch until the beverage reaches the desired level, then release.
Refrigeration Switch
The refrigeration switch is located on the rear of the dispenser near the center. This switch controls power to the
water bath pump and relay contacts for the compressor and condenser fan motor.
P3580-1
A. Product Dispense Switch
Pressing and holding switch will initiate product flow from the respective nozzle; releasing the switch will
stop the flow.
FIG 11 Dispense Lockout Switch
P3583
P3612
39992 042007
FIG 8 Refrigeration Switch - JDF-4S
B. Dispense Lockout Switch (JDF-2S shown)
This switch is located at the bottom front of the
dispenser just behind the drip tray. It is used to turn
ON and OFF the Dispensing function. It is also used
for some programming and fill procedures.
FIG 10 Product Dispense Switches - JDF-4S
P3841
P3844