Filter
Top Products
7
DEFINITIONS
COMPONENTS
• WATER RESERVOIR - Holds reserve water for brewing. The reservoir can be
removed and filled separately at a sink or other clean water source or by pouring
water through the slide lid. (Holds 1.7 L (46 oz.) to the maximum line.)
• SLIDE LID - The slide lid allows access to the reservoir. Water can be poured
through the opened lid and into the reservoir without removing the reservoir.
• POD HOLDER RELEASE BUTTON - Push to unlock and release the pod holder.
When there is power to the brewer, this button will illuminate red in color, showing
the trademark BUNN name. This light will go out during a brew cycle and when
the brewer has gone into Sleep Mode. (Refer to the “Features” section on page 8 for
more information.)
• BLUE (BREW) LIGHTS - Blue colored lights are located near the pod holder area
and light up to indicate that a brew cycle is in process.
• SPRAYHEAD SEAL - The seal keeps water under pressure from escaping, while
a brew cycle is in process. If leaks are present during a brew cycle, consult the
“Troubleshooting”
section on page 15.
• SPRAYHEAD - Designed to distribute water evenly across the coffee pod or tea
bag/pod to extract the proper flavor.
• POD HOLDER INSERT - A color-coded, removable screen designed to allow
proper flow rates and steeping capabilities for the type of brew desired.
• POD HOLDER - Holds the coffee pod or tea bag/pod.
• DRIP TRAY GRATE - A removable part that allows any spilled liquid to drip
through into the drip tray.
• DRIP TRAY- Removable tray that is designed to catch any spilled liquid.
• POWER SWITCH- Turns on and off all electrical service to the brewer. This button
is only to be used when the brewer will not be used for several days. (In the “I”
position the power is on. In the “O” position the power is off.)
• VOLUME CONTROL SLIDE LEVER - Adjusts the amount of water dispensed
through the pod holder. Sliding it left will produce a smaller serving. Sliding it to
the right will produce a larger serving. The brewer will dispense approximately
118 to 355 ml (4 to 12 oz.) in 30 ml (1 oz.) increments.
• CONTROL PANEL - Controls for brewing coffee or tea and various indicators are
located on the control panel. (FIG. 2) See specific definitions below.
CONTROL PANEL
• COFFEE BREW BUTTON - Depress this button to brew a serving of coffee. Pressing
it again will cancel a brew cycle in process.
• REFILL WATER INDICATOR - If the water in the reservoir is running low, and either
the Coffee or Tea Brew button is pressed, this indicator will flash for a few seconds
to show that the water reservoir needs to be refilled. A brew cycle cannot be started
until the reservoir has been refilled.