Bunn Smart Wave Series Coffeemaker User Manual


 
Page 9
40410 092407
PROGRAMMING - SILVER SERIES
BREW VOLUME SET-UP:
NOTE: Set small and large batches separately. Maximum water on time is 5 minutes.
Use the following steps when the setting is unknown.
1. Place an empty funnel in the funnel rails and an empty server beneath the funnel.
2. Press the "ENABLE BREW ON/OFF" switch ("ON").
3. Press and hold the small brew start switch until the LED indicator alternately flashes red/green (approximately
15 seconds). Release the switch.
4. Allow the cycle to continue until the desired amount of water is dispensed and then press the "ENABLE BREW
ON/OFF" to turn "OFF" the brewer.
The brewer is now set to dispense this amount of water for each subsequent small brew cycle.
To increase the amount of water for each brew cycle place an empty funnel in the funnel rails and an empty
server beneath the funnel. Press the "ENABLE BREW ON/OFF" switch (ON). Press and hold the small "BREW"
switch until you hear the solenoid click on-and-off three times (approximately 10 seconds), then release the small
"BREW" switch. Momentarily press and release the small "BREW" switch once for each ounce (approximate) of
water to be added to the prior setting and allow the brew cycle to finish.
To decrease the amount of water for each brew cycle place an empty funnel in the funnel rails and an empty
server beneath the funnel. Press the "ON/OFF" switch (ON). Momentarily press and release the small "BREW"
switch once for each ounce (approximate) of water to be removed from the existing setting. Press and hold the
small "BREW" switch until you hear the solenoid click on-and-off three times (approximately 10 seconds), then
release the small "BREW" switch and allow the cycle to finish.
NOTE: Repeat the steps above to set the large batch by using the large brew switch as desired.
OPTIONAL PULSE BREW SET-UP:
NOTE: Set small and large batches separately. Brewer has 4 preset pulse brew routines to choose from.
Factory default is 1. With 4 being the maximum time.
With the machine off, press the small or large switch for 10 seconds. Red LED will flash to indicate current setting
( 1 – 4 ). Press same switch the number of times ( 1 – 4 ) for the desired setting. If the switch is pressed more
than 4 times, the setting will remain at 4. After 5 seconds the red Led will resume flashing the selected number.
When no switches are pressed for 30 seconds, the mode will exit. Or the mode may be exited by pressing the
"ENABLE BREW ON/OFF" switch. Repeat above procedure with the other brew switch.
Restore Factory Defaults:
Press the "ENABLE BREW ON/OFF" switch while applying AC power. Continue pressing the "ENABLE BREW ON/
OFF" switch for 10 seconds. During that 10 seconds, the red LED will be on steady. After 10 seconds the green
LED will begin flashing rapidly for 5 seconds. During that 5 seconds, release and again momentarily press the
"ENABLE BREW ON/OFF" switch again to restore default settings. The Led will alternate rapidly Red and Green
for a few seconds indicating the restore has been accomplished.
Note: The Restore process cannot be done when Dip Switch # 1 is On (Program Lockout)