Bunn T3A Ice Tea Maker User Manual


 
Page 6
10. Install the ferrule and screen in the funnel. Load the funnel with a BUNN
®
paper filter and approximately four
ounces of loose tea leaves. Depress the start button to brew tea and observe the funnel drip out and the
dilution streams near the end of the cycle. The dilution stream should stop approximately thirty seconds after
the drip out has stopped.
11. If this does not happen, load the funnel with a fresh filter and tea, rotate the delay dial up or down accordingly
and repeat Step 10 until proper timing is achieved.
12. Replace the top panel. The brewer is now ready for normal operation.
ADJUSTING BREW VOLUMES
CAUTION - Disconnect the power source from the brewer prior to the removal of any panel for the replacement
or adjustment of any component.
NOTE: Prior to setting or modifying batch sizes, check that the brewer is connected to water supply, the tank is
properly filled, and a funnel and server are in place.
1. Modifying batch sizes. To modify a batch volume, first check that the SET/LOCK switch is in the SET
position on the circuit board.
To increase a batch size. Press and hold the START or BREW switch until three clicks are heard. Release the
switch (Failure to release the switch within two seconds after the third click causes the volume setting to be
aborted and previous volume setting will remain in memory) and press it again one or more times. Each time
the switch is pressed, two seconds are added to the brew time period. Allow the brew cycle to finish in order
to verify that the desired volume has been achieved.
To decrease a batch size. Press and release the START or BREW switch once for every two-second interval
to be removed from the total brew time period; then immediately press and hold down the START or BREW
switch until three clicks are heard. Release the switch. (Failure to release the switch within two seconds after
the third click causes the volume setting to be aborted and previous volume setting will remain in memory).
Allow the brew cycle to finish in order to verify that the desired volume has been achieved.
2. Setting batch sizes. To set a batch volume, first check that the SET/LOCK switch is in the SET position on
the circuit board. Press and hold the START or BREW switch until three distinct clicks are heard, and then
release the switch. (Failure to release the switch within two seconds after the third click causes the volume
setting to be aborted and previous volume setting will remain in memory). View the level of the liquid being
dispensed. When the desired level is reached, turn the ON/OFF switch to OFF (lower). The brewer remem-
bers this volume and will continue to brew batches of this size until the volume setting procedure is repeated.
NOTE: When brewing coffee, batch volumes will decrease due to absorption by the coffee grounds.
3. Setting programming disable feature. If it becomes necessary to prevent anyone from changing brew times
once programmed, you can set the SET/LOCK switch to the LOCK position. This will prevent any program-
ming to be done until switch is once again placed in the SET position.
OPERATING CONTROLS
A. ON/OFF SWITCH (T3 ONLY)
ON - Placing the switch in the"ON" (left) position allows the start switch to activate a timed brew cycle for three
gallons of tea.
OFF - Placing the switch in the "OFF" (right) position stops the brew cycle. Stopping a brew cycle after it has been
started will not stop the flow of water into the funnel until the tank syphons down to its proper level. The switch
should always be placed in this position after a brew cycle and whenever the brewer is unattended.
INITIAL TIMER ADJUSTMENT (cont.)
10145 072600