Bunn TB3Q Hot Beverage Maker User Manual


 
Page 11
41465.1 042009
CLEANING
CAUTION - CLEAN AND SANITIZE YOUR ICED TEA BREWER DAILY
DAILY:
1. Remove, disassemble and thoroughly clean and sanitize the entire brew funnel. The funnel tip and screen
must be free from any tea particles or residue. Reassemble the funnel.
2. Place the ON/OFF switch in the "OFF" position. Remove and thoroughly rinse the sprayhead. The holes must
be open and clear of any mineral deposits. Wipe the sprayhead panel clean with a damp cloth.
3. Insert the deliming spring into the sprayhead fitting until no more than two inches is visible and move it in
and out 5 or 6 times. Reattach the sprayhead.
4. Wash the entire outside surface of the brewer (including the sprayhead panel) with a clean damp cloth.
CAUTION - DO NOT KEEP BREWED ICED TEA OVERNIGHT. THE SERVER MUST BE CLEANED DAILY.
WEEKLY:
1. Remove and thoroughly rinse the sprayhead. The holes must be open and clear of any mineral deposits.
Reattach the sprayhead.
NOTE: Refer to the "Care and Cleaning" card (37244.0000) at http://www.bunnomatic.com/pdfs/commercial/
careclean/37244.0000.pdf for detailed instructions on cleaning and sanitizing the brewer and dispensers.
AUTO SWEETENER CLEANING
1. Remove the connector off of the bag in a box.
2. Place the end in a bucket of hot water (120°-130°F)
3. Place an empty reservoir on the base under the dilution nozzle.
4. Set the selector switch to the "Sweetened" setting.
5. Press and release the "Start" switch.
6. Run three brew cycles in a row, emptying the reservoir after each cycle.
7. When the three cycles have been completed, hook the connector back up to the bag in a box system. (This
will keep buildup from occurring in the system.)
This procedure should be performed weekly or as needed to keep the system clear.