Filter
Top Products
Page 6
TROUBLESHOOTING (cont.)
PROBLEM
Dripping from sprayhead
Beverage overflows dispenser
Weak beverage
PROBABLE CAUSE
REMEDY
1. Lime Build-up
CAUTION - Tank and tank
components should be delimed
regularly depending on local
water conditions. Excessive
mineral build-up on stainless
steel surfaces can initiate corro-
sive reactions resulting in
serious leaks.
1. Dispenser
1. Filter Type
2. Coffee Grind
3. Sprayhead
4. Funnel Loading
5. Water Temperature
Inspect the tank assembly for
excessive lime deposits. Delime
as required.
The dispenser must be com-
pletely empty before starting a
brew cycle.
BUNN
®
paper filters must be used
for proper extraction.
A fine or drip grind must be used
for proper extraction.
A six-hole stainless steel spray-
head must be used for proper
extraction.
The BUNN
®
paper filter must be
centered in the funnel and the bed
of grounds leveled by gentle shak-
ing.
Place an empty funnel on an empty
dispenser beneath the sprayhead.
Pour-in a pitcher of tap water and
check the water temperature im-
mediately below the sprayhead
with a thermometer. The reading
should not be less than 195°F.
Adjust the control thermostat to
increase the water temperature.
Replace if necessary.
10053 011597