Butler 645-045 Coffeemaker User Manual


 
hot plate. Insert the filter holder. Fill the
coffee maker with cold water, press the start
button on the front of the machine, and
allow the water to flow through the coffee
maker.
The coffee maker is now ready for use.
Brewing:
1. Lift the lid and fill the water container
according to the number of coffee cups
desired (minimum 2 cups). There is an
indicator on the side of the coffee
maker that indicates the water level.
NB. Never pour water into a hot coffee
maker. Wait approximately 10 minutes
before brewing the next pot of coffee.
2. Open the lid of the coffee maker. Insert
a filter (size 1x4) into the filter holder and
place the desired amount of coffee into
the filter (approximately one measure
per cup). Close the lid. The filter holder
is equipped with a function that
prevents dripping from the filter holder
when the pot is lifted from the hot plate.
To start brewing, press the button on
the front of the coffee maker.
3. The coffee maker is equipped with a hot
plate that heats up automatically when
you switch the coffee maker on. This
keeps the coffee hot as long as the
coffee maker is plugged in.The switch
has a built-in light that illuminates when
the coffee maker is on.
DECALCIFYING
- Mineral deposits can clog your coffee
maker. To keep your coffee maker
operating efficiently, you must regularly
clean out mineral deposits left by the
water; they can build up and clog your
coffee maker. At least once a month,
use the household cleaning solution
descibed below, to prevent this
clogging.
- You should clean your coffee maker
every 2 weeks if the water in your area
is especially hard. Frequent cleaning
may improve coffee flavor brewing time.
Household cleaning solution.
- Pour 1 quart of white vinegar into the
carafe. Then, add cold water to the
vinegar until it reaches the 10/12 cup fill
line on the carafe. Pour water and
vinegar into the water tank.
- Place carafe on the hotplate. Switch the
coffee maker on.
- Let half of the mixture run through the
coffee maker. Turn off the coffee maker
for approx. 10 minutes.
- Turn on the coffee maker again and let
the rest of the mixture run through the
coffe maker.
- Let the coffee maker cool 10 minutes,
then rinse the coffee maker by filling the
carafe with cold water up to the 10/12
cup fill line. Pour water into water tank
and turn the coffee maker on. Repeat
this procedure 3 times.
Never submerge the coffee machine in
water.
ENVIRONMENTAL TIP
An electronic appliance should, when it is no
longer capable of functioning be disposed
with least possible environmental damage.
The appliance should be disposed
according to the local regulations in your
municipality, in most cases you can
discharge the appliance at your local
recycling center.
THE WARRENTY DO NOT COVER
- If the above points have not been
observed.
- If the appliance has not been properly
maintained, if force has been used
against it or if it has been damaged in
any other way.
- Errors of faults owing to defects in the
distribution system.
- If the appliance has been repaired or
modified or changed in any way or by
any person not properly authorized.
11
CMT-130 IM 24/03/03 8:43 Side 11