Filter
Top Products
4. When the 10 minutes are up, switch the
coffee maker on again and allow the
remainder of the solution to run through
it.
5. To remove the final residues of limescale
and acetic acid, pour a potful of cold
water into the water reservoir, switch the
coffee maker on and pass the water
through it.
6. Pass fresh water through the machine 3
times (as described in point 5).
7. The coffee maker is now ready for use
again.
INFORMATION ON DISPOSAL OF THIS
PRODUCT
Please note that this Adexi product is
marked with this symbol:
This means that this product must not be
disposed of together with ordinary
household waste, as electrical and
electronic waste must be disposed of
separately.
In accordance with the WEEE directive,
every member state must ensure correct
collection, recovery, handling and recycling
of electrical and electronic waste. Private
households in the EU can take used
equipment to special recycling stations free
of charge. In some member states you can,
in certain cases, return the used equipment
to the retailer from whom you purchased it,
if you are purchasing new equipment.
Contact your retailer, distributor or the
municipal authorities for further information
on what you should do with electrical and
electronic waste.
GUARANTEE TERMS
The guarantee does not apply:
• if the above instructions are not followed
• if the appliance has been interfered with
• if the appliance has been mishandled,
subjected to rough treatment, or has
suffered any other form of damage
• if faults have arisen as a result of faults in
your electricity supply.
Due to the constant development of our
products in terms of function and design,
we reserve the right to make changes to the
product without prior warning.
IMPORTER
Adexi Group
16
645085_IM 08/01/07 14:26 Side 16
FOR UNITED KINGDOM ONLY
Plug wiring:
This product is fitted with a BS 1363
13-amp plug. If you have to replace the
fuse, only those that are ASTA or BSI
approved to BS1362 and with a rated
current of 13 amps should be used. If there
is a fuse cover fitted, this cover must be
refitted after changing the fuse. If the fuse
cover is
lost or damaged, the plug must not be
used. You must also check if the socket
outlets in your home fit with the plug of the
appliance. If the socket outlet in your home
does not fit with the plug, the plug must be
removed and disposed of safely as
insertion of the plug into the socket is likely
to cause electric hazard. A replacement
plug should be wired according to follow-
ing description.
Important
This appliance must be earthed. The wires
in the cord set are coloured thus:
BLUE- Neutral, Brown-Live, Green& Yellow-
earth (For detachable plug only)
As the colours of the wires in the mains
lead of this appliance may not
correspond with the coloured markings
identifying the terminals in your plug,
proceed as follows:
The wire that is coloured Green& Yellow
must be connected to the terminal in the
plug that is marked with the letter E or by
the earth symbol, or coloured green&
yellow.
The wire that is coloured blue must be
connected to the terminal that is marked
with the letter N or coloured black.
The wire that is couloured brown must be
connected to the terminal that is marked
with the letter L or coloured red.