Cadco CG-20 Griddle User Manual


 
2
3
HOW TO USE
(Before using for the first time, become familiar with the griddle features, Figure B.
Wash griddle in warm sudsy water, rinse and dry. Do not submerge plug or let the
plug come in contact with any liquid. )To "season" the nonstick properties of the
surface coating, rub the cooking surface of the griddle lightly with cooking oil. Season
with each use to maintain the nonstick properties.
1. Prepare food for cooking.
2. Plug unit into appropriate 3-prong wall socket. Press power rocker switch to On
and turn heat control to desired temperature. Preheat griddle for at least 5 minutes
before placing food on it. Pilot light will turn off when selected temperature is
reached. During cooking, pilot light will go on and off, indicating desired temperature
is being maintained.
3. Because the griddle features a nonstick finish, food may be prepared with or without
shortening, according to taste.
4. Place food on griddle and cook according to temperature
time table (page 4). Heat should be adjusted according to
personal preference and particular food being cooked.
Temperatures and times in the table are approximate.
5. Turn heat control to OFF when cooking is completed. Then
press power rocker switch to OFF. Unplug from wall outlet.
Allow unit to cool completely before removing grease
tray to empty, or removing splash guard. Grease tray
and splash guard are made of stainless steel for durability.
During use, they get very hot. Extreme care should be
used when handling, emptying, etc. As a precaution, always use a hot mitt or potholder.
CARE AND CLEANING
Before initial use and after each subsequent use, disassemble splash guard and
wash griddle and splash guard with warm sudsy water, rinse and dry. DO NOT
IMMERSE GRIDDLE OR PLUG IN WATER OR LET PLUG COME IN CONTACT WITH
ANY LIQUID. Season the cooking surface after each cleaning by rubbing with cooking
oil to maintain the nonstick properties.
To maintain the integrity of the nonstick coating, only nylon, plastic, wooden or
rubber utensils should be used. Metal utensils may be used, bur over time they will wear
off the nonstick coating. Do not use a knife to cut the food on the cooking surfaces.
This is a UL Listed appliance. The following important safeguards are
recommended by most portable appliance manufacturers.
IMPORTANT SAFEGUARDS
To reduce the risk of personal injury or property damage when using electrical
appliances, basic safety precautions should always be followed, including the
following:
1. READ ALL INSTRUCTIONS.
2. Do not touch hot surfaces. Use handles. Use hot mitts or potholders.
3. To protect against electrical shock, do not immerse unit base, cord or plug
in water or other liquid.
4. Close supervision is necessary when any appliance is used by or near
children.
5. Unplug from outlet when not in use and before cleaning. Allow to cool
before putting on or taking off parts, and before cleaning the appliance.
6. Do not operate any appliance with a damaged cord or plug or after the
appliance malfunctions or has been damaged in any manner.
Contact the Cadco Factory Service Department at (860) 738-2500
for examination, repair or adjustment. In Canada call (905) 825-9665
.
7. The use of accessory attachments not recommended by the appliance
manufacturer may cause injuries.
8. Do not use outdoors.
9. Do not let cord hang over edge of table or counter or touch hot surfaces.
10. Do not place on or near a hot gas or electric burner or in a heated oven.
11. It is recommended that this appliance not be moved when it contains hot
oil or other hot liquid.
12. ALLOW GREASE TRAY TO COOL COMPLETELY BEFORE REMOVING.
13. To disconnect, turn heat control to "OFF", push power rocker switch to OFF,
then remove plug from wall outlet
14. Do not use appliance for other than intended use.
SAVE THESE INSTRUCTIONS
CAUTION: For safety's sake, when using non-stick cookware or electric appliance with
nonstick coatings, keep your pet birds out of the room. Birds have respiratory systems
that are sensitive to many kinds of fumes, including fumes from overheated nonstick
cookware.
NOTE: A short power supply cord (or cord set) has been provided to reduce the hazards
resulting from becoming entangled in or tripping over a longer cord. Longer cord sets or
extension cords may be used if care is properly exercised in their use. If a long cord set
or extension cord is used, the marked electrical rating of the cord set or extension cord
should be at least as great as the electrical rating of the appliance. The longer cord should
be arranged so that it will not drape over the counter top or table top where it can be
pulled on by children or tripped over accidentally.
ASSEMBLY
Please read these instructions carefully. Refer to Figure A.
1. Place unit securely on table or counter.
2. Position the splash guard on the cooking surface with the long side parallel to the
back of the griddle, and the splash guard arms facing forward. The back of the splash
guard should sit on the back of the cooking surface.
3. Position the two metal tabs of the splash guard into the slots in the thumbscrews on
each side of the griddle. You may need to push the sides in toward the griddle housing
to get the tabs positioned in the slots. This should keep the splash guard snugly fitted
to the griddle. (There is no need to turn the thumbscrews.) Press down to seat the
splash guard on the griddle.
4. To remove for cleaning, pull splash guard up until the side tabs disengage from the
side thumbscrew slots. Allow unit to cool before removing splash guard.
5. Slide grease tray into place at the bottom fronmt of the griddle. Never use the griddle
without grease tray in place. Allow unit to cool before removing grease tray.
Figure BFigure A
Non-stick
Cooking
Surface
Grease Tray
Heat
Control
Splash Guard
Tab
Splash Guard
Rear Leg
Power
Rocker
Switch
Pilot
Light
Thumbscrews
Tab
190
265
355
400
475
150
Approximate
Temperatures