Cadco OV-500 Convection Oven User Manual


 
exterior walls before you begin cooking food
in your new Cadco convection oven. Most
solvents or degreasers will remove any
residue.
4. INSTALLATION
4.1 ELECTRICAL CONNECTION
The connection to the electrical power supply
network must be done according to the stan-
dards in force.
Before connecting make sure that the voltage
and the frequency correspond to that stated
on the data plate on the oven.
Place a bi-polar switch between the oven
and the network accessible after installation,
whose contacts have a minimum opening
distance of 0.1 inches, with an appropriate
input (for example, magnetothermal switch).
When the oven is in operation, the power
supply voltage must not vary from the value
of the nominal voltage by more than ± 10%.
The oven must be connected to the
ground line of the network.
3.2 INSTALLATION LOCATION
Make sure you have the correct power sup-
ply for the oven model you have purchased.
Check the technical data sheets at the back
of this manual if you are in doubt.
Do not install any Cadco-Unox Convection
Oven directly on the floor. Cadco has oven
stands to perfectly elevate your oven as well
as provide pan storage.
OST-34A for models OV-350 and OV-400
OST-56A for models OV-500 and OV-600
If the oven must be placed near walls,
dividers, or moldings Cadco recommends
they be made of non-combustible materials.
Be sure to observe all safety and fire codes
when positioning your convection oven.
All of our convection ovens have a vapor vent
in the back of the unit. When installing your
convection oven, leave a space of 4” [mini-
mum] between the back of the oven and the
wall, and 2” minimum on the top and sides.
Where applicable, ventilation hood require-
ments vary according to local codes.
We do not suggest using the Cadco-Unox
Convection Ovens for built in applications.
Measure to make sure that your new oven
will fit in your available space.
3.3 REMOVE THE PROTECTIVE FILM
Be sure to remove the laser film from the
ENGLISH
4
ENGLISH
XA030/OV-400
XA085/OV-500
XA006/OV-250
XA015/OV-350
XA090/OV-600
Use only AWG10 cords
220-230 V ~
21 3 54
L L
L2
L2
208 - 240V
208-240V