Filter
Top Products
LEVELLING
Two rear wheels and two front feet are fitted which can be adjusted up or down to set
the height (915mm) and level the cooker.
1. The rear wheels can be raised or lowered from the BACK of the cooker by
adjusting the levelling screws ‘A’ in the plinth.
2. The front feet can be simply screwed in or out to lower or raise the front of the
cooker.
CAUTION: Some soft floor coverings may get damaged if the cooker is not moved
carefully.
NOTE: Ensure oven shelves are level by using a spirit level on the rod shelves
VIEWED FROM REAR
STABILITY BRACKET
The back of the cooker has a slot for engagement of a stability bracket, which can
be obtained, as an extra, from your cooker supplier.
CONNECTING TO GAS SUPPLY
The cooker is designed to match the depth of standard 600mm worktops. An
adaptor backplate should, therefore, be fitted within the shaded area shown to
allow the cooker to be pushed fully to the wall.
Connection to the cooker should be made with an approved appliance flexible
connection to BS 669. Hoses connected to LPG should be suitable for LPG and
capable of withstanding 50mbar pressure A length of 0.9 to 1.25m is
recommended. The length of hose chosen should be such that when the cooker is
in situ, the hose does not touch the floor.
The temperature rise of areas at the rear of the cooker that are likely to come in
contact with the flexible hose do not exceed 70˚C.
STABILITY
BRACKET
POSITION
GAS
BACKPLATE
POSITION
125mm
450 mm
635mm
27
SLOT FOR
STABILITY
BRACKET
REAR OF
COOKER
220mm
70mm
INSTALLATION INSTRUCTIONS