Filter
Top Products
31
Care and Cleaning
Carefully slide the inner glass towards you and withdraw it from its
locating slots.
Ensure that the door is not allowed to slam shut, due to the
reduction in door weight.
Clean the glass as described above.
Refit the door inner glass as follows.
1. Open the door fully.
2. Locate the inner door glass into its slots, so that the printing is readable from the face
nearest the oven in the closed position and the widest black band is towards the bottom of
the door. The inner door glass has a special reflective coating on one side, in order to
minimise surface temperatures and energy consumption during use, it is important it is
fitted correctly.
3. Carefully slide the glass into its slots as far as it will go.
2.
3. The inside of the outer door glass can now be cleaned while still fitted to the cooker.
NEVER OPERATE THE COOKER WITHOUT THE INNER DOOR GLASS IN POSITION.
Note: The two clamping plates can be undone and rotated away from the glass - Therefore
they can remain in the door inner whilst cleaning.
CLEANING THE DOORS
Take particular care not to damage the inner surface of the door inner glass that is coated
with a heat reflective layer. Do not use scouring pads, or abrasive powder, which will
scratch the glass. Ensure that the glass panel is not subjected to any sharp mechanical
blows.
Stubborn stains can be removed by using a fine steel wool soap pad.
For slight soiling the inner
glass panel may be cleaned, while still warm, without removing it from the door. After cleaning,
rinse and dry with a soft cloth.
SIDE OPENING DOORS
Cleaning the door glass is the same as the drop down doors, except take care to support
the weight of the inner glass when removing and refitting.
DROP DOWN DOORS - PROFESSIONAL and TRADITIONAL
Remove the door inner glass as follows.
1. Open the door fully.
2. Unscrew the two screws securing the glass panel, taking care not to allow the glass to fall.
Clean the glass as described above.
Refit the door inner glass as follows.
1. Open the door fully.
2. Position the glass panel onto the inner door, making sure the printed text on reflective
coatings are facing the oven (Not all panels).
3. Refit the two clamping plates and secure with the two original screws.
DROP DOWN DOORS - YORK
Remove the door inner glass as follows.
1. Open the door fully.