Filter
Top Products
WARNING: TO AVOID ELECTRIC SHOCK, BEFORE REPLACING THE OVEN LIGHT, SWITCH THE
COOKER OFF AT THE COOKER CONTROL UNIT (and allow to cool if the oven has been used).
28
Care and Cleaning
Oven Fittings
Oven Interiors
Oven Door Cleaning
Cooker Exterior
Door and Control
Panel (Glass)
Replacement of the
Oven Light
The oven shelves can be cleaned either in a dishwasher or by using a
fine steel wool soap pad. The grill and meat pans can be cleaned in warm
soapy water using a fine steel wool soap pad to remove stubborn stains
or in a dishwasher.
They should be cleaned after each use.
To clean the oven interiors remove all the oven fittings and where
applicable the ‘Heat Clean’ liners.
All types of oven cleaners can be used, but do not allow abrasive
cleaners or oven spray to come into contact with the ‘Heat Clean’ liners.
Use a fine steel wool soap pad to remove stubborn stains.
Wipe the outer door glass panels with a cloth wrung out in warm soapy
water, then after wiping with a cloth wrung out in clear water, dry with a
soft clean cloth. Ensure that the glass doors are not subjected to any
sharp mechanical blows.
Glass inner door panel (where fitted) - open the door fully and unscrew
the two screws securing the glass panel, taking care not to allow the glass
to fall. The glass panel may now be washed at the sink. Stubborn stains
can be removed using a fine steel wool soap pad. Ensure the glass panel
is not subjected to any sharp mechanical blows. Take particular care not
to damage the inner surface which is coated with a heat reflective layer.
After cleaning, rinse and dry with a soft cloth. For slight soiling the inner
glass panel may be cleaned, while still warm, without removing it from
the door.
WARNING: Oven must not be operated with the inner door glass
removed.
Take care during cleaning not to damage or distort the door seals. Do
not lift the door seal from the oven chassis, if necessary remove the seal
by carefully unhooking the corner clips.
Take care that the rating label edges are not lifted during cleaning and
furthermore, that the lettering is not blurred or removed.
The outside of the cooker should be cleaned regularly to keep it looking
like new.
Wipe over with a soft cloth wrung out in warm water and dry with a soft
clean cloth.
You can use mild non abrasive cleaners but always read the
manufacturer’s instructions first. Always test their suitability on a small
area of the cooker not noticeable in normal use.
Note: Do not use scouring pads or abrasive cleaners as they may
scratch the surface.
Wear protective gloves when cleaning any part of your cooker.
Regularly wipe with a clean, damp cloth and polish with a clean, dry cloth.
Unscrew the glass cover, using a suitable cloth to protect the fingers and
remove carefully. Unscrew the existing light bulb, and remove. Screw the
new bulb into position and replace the glass cover, with metal washer,
until positioned securely.