Filter
Top Products
1
Models 750, 751, 754, 774, 794 To t he Installer
050418
Section 1 To the Installer
This machine is designed for indoor use only.
DO NOT install the machine in an area where
a water jet c ould be used to clean or rinse the machine.
Failure to follow this instruction may result in serious
electrical shock.
Water Connections
(Water Cooled Units Only)
An adequate cold water supply must be provided with
a hand shut-off valve. On the underside rear of the
base pan, two 3/8” I.P.S. (for single-head units) or two
1/2” I.P.S. (for double-head units) water connections
for inlet and outlet have been provided for easy
hook-up. 1/2” inside diameter water lines should be
connected to the machine. (Flexible lines are
recommended, if local codes permit.) Depending on
local water conditions, it may be advisable to install a
water strainer to prevent foreign substances from
clogging the automatic water valve. There will be only
one water “in” and one water “out” connection for both
single-head and double-head units. DO NO T ins tall a
hand shut-off valve on the water “out” line! Water
should always flow in this order: first, through the
automatic water valve; second, through t he
condenser; and third, through the outlet fitting to an
opentrapdrain.
Air Cooled Units
The model 750 air cooled unit requires a m inimum of
6” (152 mm) of clearance on both s ides and 0” in the
rear of the unit. The model 751, 754, 774 and 794 units
require 3” on all sides. This will allow for adequate air
flow across the condenser(s). Failure to allow
adequate clearance can reduce the refrigeration
capacity of the freezer and possibly cause permanent
damage to the compressor.
Electrical Connections
Each freezer requires one power supply for each data
label. Check the data label(s) on the freezer for fuse,
circuit ampacity and elec trical specifications. Refer to
the wiring diagram provided inside ofthe electrical box,
for proper power connections.
In the United States, this equipm ent is intended to be
installed in accordance with the National Electrical
Code (NEC), ANSI/NFPA 70--1987. The purpose of
the NEC code is the practical safeguarding of persons
and property from hazards arising from the use of
electricity. This code contains provisions considered
necessary for safety. Compliance therewith and
proper maintenance will result in an installation
essentially free from hazard!
In all other areas of the world, equipment should be
installed in accordance with the existing local codes.
Please contact your local aut horities.
Stationary appliances which are not equipped with a
power cord and a plug or other device to disconnect
the appliance from the power source must have an
all--pole disconnecting device with a contact gap of at
least 3 mm installed in the ex ternal installation.
CAUTION: THIS EQUIPMENT MUST BE
PROPERLY GROUNDED! FAILURE TO DO SO
CAN RESULT IN SEVERE PERSONAL INJURY
FROM ELECTRICAL SHOCK!
Beater rotation must be clockwise as viewed looking
into the freezing cylinder of any model freezer.
Note: The following procedures should be
performed by a trained service technician.
To correct rotation on a three-phase unit , interchange
any two incoming power supply lines at freezer main
terminal block only.
To correct rotation on a single-phase unit, change the
leads inside the beater motor . (Follow diagram printed
on motor.)
Electrical connections are made directly to the
terminal block provided in the main control box located
under the upper left side panel on the Model 750, or