CDA 6Q5 Oven User Manual


 
20
Electronic Clock (fig. 8)
The programmer is equipped with an electronic clock with illuminated numbers which indicates hours
and minutes. Upon immediate connection of the oven or after a power cut, three zeros will flash on the
programmer display.
To set the correct time of day it is necessary to push the
button and then the or button until
you have set the correct time. In another way push simul tane ously the two buttons and at the same
time push the or button.
Note: If the clock is reset it deletes any previously set programs.
Normal Cooking without the Use of the Programmer
To manually use the oven, that is, without the aid of the programmer, it is necessary to cancel the flashing
AUTO by pushing the button (AUTO will be switched off and the symbol will go on - Fig. 9).
Attention: If the AUTO is steadily lit (which means a cooking program has already been set), the program
can be cancelled and switched to manual by pushing the button .
If the oven is switched on, you must switch off manually.
Electronic Timer
The timer program consists only of a buzzer which may be set for a maximum period of 23 hours and 59
minutes. If the AUTO is flashing push the button.
To set the time, push the button and the or until you obtain the desired time in the panel
(fig. 10). Having finished the setting, the clock hour will appear on the panel and the symbol will be
illuminated.
The countdown will start immediately and may be seen at any moment on the panel by simply pressing
the button .
At the end of the time, the symbol will disappear and the buzzer will sound and continue for
approximately 7 minutes or until a button is pressed (not the / buttons).
After a short time the display will revert back to the time of day.
Setting the Frequency of the Audible Signal
The buzzer has 3 different tones and can be changed by pressing the button, but only when the time
of day is displayed.
Fig. 9 Fig. 10