Filter
Top Products
How to install the hob:
Overall dimensions of the hob: Width: 585mm Depth: 500mm
Worktop cut-out dimensions: Width: 550mm Depth: 470mm
1. Make the required hole in the worktop. Before doing this, you must check the instructions supplied with any cooker
hood to ensure that you will have the required clearance. The cut-out (Fig.7) shows a 65mm gap from the wall to the
cut-out edge. The distance from the hob, when fitted, to the back wall is 50mm.
If a splashback/worktop upstand is to be fitted, take this into account when cutting the hole. The minimum distance that the
hob should be positioned away from the rear wall or splashback is 50mm.
2. Position the hob seal, as shown in Fig.9, ensuring that the ends meet without overlapping. Do not use silicone type sealant.
3. Secure the hob to the worktop using the fixing brackets and screws supplied, as shown in Fig.10. Remove any excess
sealant after tightening the brackets. Do not over-tighten the fixing brackets.
3cm
4cm
Fig.10Fig.9
Fig.7 Fig.8
65mm
470mm
550mm
185mm 185mm
400mm
700mm