Filter
Top Products
10
F
C
Fig. 8
Fig. 7
Burners and Grids
– These parts can be removed and cleaned with appropriate products.
– After cleaning, the burners and their flame spreaders must be well dried and correctly replaced.
– It is very important to check that the burner flame spreader and the cap have been correctly positioned.
Failure to do so can cause serious problems.
– Check that the electrode “S” (figs. 7 - 9) is always clean to ensure trouble-free sparking.
– Check that the sensor “T” (figs. 7 - 9) next to each burner is always clean to ensure correct operation of
the safety valves.
– Both the probe and ignition plug must be very carefully cleaned.
– Note: To avoid damage to the electric ignition do not use it when the burners are not in
place.
Correct Positioning of the Burners (Auxiliary, Semi-rapid and Rapid burners)
– It is very important to check that the burner flame spreader “F” and the cap “C” have been correctly
positioned (see figs. 7 and 8). Failure to do so can cause serious problems.
Ignitor “S”
Sensor “T”