Filter
Top Products
ATTENTION：The following steps are for the Microwave Oven models with the Built-in Trim Kit
Frame Only.
1. After taking all the accessories out of the microwave oven, turn the microwave oven over on its
back and keep the base of the microwave oven facing towards you.
2. Remove the adjustable feet (Fig. No. 2) from the plastic bag and screw them into the holders
(Fig. No. 1), one by one.
3. Once all 4 feet are fitted, turn the microwave oven back over onto its feet to check if the adjust-
able feet are level. If the microwave oven is unstable, adjust the feet by screwing them up or down
accordingly.
1
2
SCHEMATIC DIAGRAM
*CIRCUIT SUBJECT TO CHANGE WITHOUT NOTICE
( DOOR CLOSED,COOK OFF CONDITION)
C4
N
E
N
L
L
HEATER
CONVEC.
HEATER
CM
C
FM
TM
R2R3
SW2
RY
D2
D1
T( IN)
R4-1
P( OUT)
N
C2
R1
C1
L
T
RY2
SWB
RY1RY4
RY3
SO
SH
H.V.
FU1
NOISE FILTER
C3
F1
L
L
SWA
FU2
SWC
TRANSFORMER
FA
F
MAGNETRON
F2
THERMISTOR
CM: CONVECTION MOTOR
SWC: THE THIRD DOOR SAFTY CONTROL SWITCH
SWB: THE SECOND DOOR SAFTY SWITCH
SWA: THE FIRST DOOR SAFTY SWITCH L: LAMP
FM: FAN MOTOR
TM: TURNTABLE MOTOR
R4-2
RECTIFIER
CONTROLLER