Filter
Top Products
6
2
5
2
>
During winter months, if you don’t need the icemaker for a long time, please take out ice
cubes from the ice compartment, and wash the bin with warm water, then replace it back
after wiping it dry. Shut off
the water supply to the refrigerator
Freezer Compartment Ab
How to use the icemaker
The ice maker can produce 8 cubes at a time. The icemaking capacity depends on
ambient temperature, frequency of door openings and inner temperature of freezer
compartment.
NOTE
After the refrigerator is installed and started, allow 24 hours
for the freezer compartment to cool down before the initial icemaking.
For initial icemaking, discard the first batches of ice cubes produced. This is also applicable
If the icemaker has been idle for a long period of time. Arrange ice cubes
in the ice bin from time to time to ensure the maximum storage. Eight ice cubes are
produced at a time. It’s normal that some of them may get frozen to each other.
If this is your first icemaker
If ice cubes have been stored too long
You may hear some creaking noise when the icemaker is running. That’s normal.
1
3
5
If ice compartment is not used during winter
6
Ice cubes may get gray and off-taste. Please discard old ice cubes and clean the ice bin with
warm water regularly. Before replacing the ice bin, make sure it cools down to ambient
temperature and air dries, or otherwise ice cubes may stick to other parts of the icemaker
and reduce ice production.
Adjustable partition wall of freezer drawer
Replacing the Light Bulb
A movable partition wall is provided in the freezer drawer to divide
the drawer into two parts. You may move the partition wall right or
left to meet your storage needs.
Bulb specifications: 220V~, 25W
Socket: E14 (DO NOT use a bulb over 25W)
To replace the light bulb:
Unplug the appliance.
Remove the front screw with a
screwdriver.
2
To remove the light cover,
press the stopper at front out
of the square hole.
3
Pull the cover forward until
the retainer is separated
from the square hole.
Turn the bulb anticlockwise and remove.
Replace a bulb of the same
specifications in the reverse sequence
of removal.
To replace the light cover: Replace the retainer
into the square hole and then press the shield front
until the stopper is locked in the square
hole. Replace and tighten the screw.
Screw hole
Square
hole
Freezer light socket
Stopper
Retainer
Storing Food in Freezer CompartmentStoring Food in Freezer Compartment
Allow warm foods to cool down before
putting them into the freezer.
Store food in smaller packages. This will
make it easier to freeze the food and
provide better quality when the food is
thawed. It’s recommended that each
package should not exceed 2.5kg.
Wrap food before storing. Make sure
the wrappings are dry to prevent them
from sticking to each other. The
wrapping materials used should be
odourless airtight, leak-proof, nontoxic
and environmental friendly to prevent
unpleasant odour or food deterioration.
The food package should indicate
information such as type of food, date
of storage and expiry date.
Once thawed, food cannot be returned
to the freezer unless it has been
cooked. Always get frozen food from
the freezer for thawing according to
actual needs.
Do not put too much fresh food in your
freezer. The freezing capacity (as
indicated in the Technical Data sheet)
should be observed.
freezer bulb freezer bulb
If icemaker is not used
If you don’t need the icemaker , take down the icemaker shelf and it can be used as freezer room.
7