Filter
Top Products
Installation
Important
If the oven is being installed into a built under oven housing unit ensure that the front rail at the top of the unit is not
installed as it could restrict ventilation.
Ensure that air can flow freely around the housing area. If the oven is being installed into a fully enclosed built-under
oven housing unit it may be necessary to cut a small slot in the top of the plinth fitted under the unit. Cut a section
400mm wide and a minimum of 15mm high to allow air to pass under the unit. Alternatively cut a section 400 x450mm
in the base of the carcass as indicated.
Failure to allow adequate ventilation to the appliance may result in overheating or damage to adjacent units and could
invalidate the warranty.
The walls of the kitchen units must be able to withstand temperatures of 75°C above ambient (typically this is between
90°C and 100°C). This appliance is type X installation.
When correctly installed ensure that there is a gap of 6mm minimum between the sides of the oven and adjacent
furniture doors.
Lift the oven carefully into position on the shelf, taking care NOT to lift it by the door handle. If you open the oven
door, you will see 2 screw holes, 1 on each side of the oven. The oven should then be secured to the housing by fitting
screws into these holes. Remember the housing should not be free standing but be secured to the wall and/or adjacent
fittings.
How to install your oven
You will need the following housing area fit your oven correctly.
The oven is designed to fit into a cabinet of 600mm width. The
oven can be built in or built under the kitchen units, but you must
ensure that it is properly ventilated. In the diagram the built-in
oven is ventilated by means of a space at the top of the kitchen
cabinet. There are many other methods of ventilating your oven -
Consult a qualified engineer for advice.
fig. 14
Dimensions Oven Housing
Height (mm) 457 450
Width (mm) 592 560
Depth (mm) 571 560 (min)
Mueble y caracteristicas técnicas
52 lt
48 lt 48 lt
Volumen útil del horno
212 Statico Rev2 del 3/03 08-04-2005 10:05 Pagina 85
400
560
560
560
450
575
575
100
560
450
499
20-24
598
594
558
573
Características eléctricas
Resistencia grill 1800 W
Resistencia circular 2100 W
Bombilla iluminación max 25 W
86
550
457
592
22
549
450
450
13