Filter
Top Products
Starting a Programme
• Turn on the water tap
• Press the Power button.
• Press the Programme Selection button until the required programme light is illuminated.
When you close the door, the dishwasher will beep once and the programme will start automatically.
The Delay Timer
This dishwasher is equipped with a variable delay timer which can be set for 2, 4, 6, 8, 10 or 12 hours’ duration.
• To set the delay timer, first switch the dishwasher on by pressing the power button. Then press the delay timer button.
The delay timer will switch on and the selected delay timer indicator will illuminate.
• To change the duration, press the delay timer button again until the required time is shown on the indicators as
shown below.
• Once the delay timer is set, then select the programme as described above.
• To cancel the delay timer before the programme has begun, press the delay timer button repeatedly until all the
indicator lights go out.
Quick wash function
This dishwasher is equipped with a function that reduces the duration of the wash, minimising water and energy
consumption.
• To set the quick wash function, select a programme as described above and then press the quick wash button so the
quick wash indicator light is illuminated.
• To cancel the quick wash function before the programme has begun, press the quick wash button and the quick wash
indicator light will go out.
Cancelling or Changing a programme
If possible do not open the dishwasher door once the programme has started.
If it is necessary to cancel or change a programme once it has started, follow the steps below:
• First open the door slightly to reduce the risk of water spillage.
• Press the Programme Selection button for approximately three seconds until the Programme Indicators go out.
• Close the dishwasher door to allow the dishwasher to run a drain cycle.
Once the drain cycle is complete, the dishwasher can now be set to a new programme if necessary.
Please note: If the cancelled programme has already used the detergent and drained the wash water, the
detergent dispenser must be refilled.
At the End of a Programme
When the dishwasher programme is complete, the dishwasher will beep six times and the Programme Indicators will go
out. Open the dishwasher door.
• Press the Power button to switch off the dishwasher.
• Turn off the water tap and remove the plug from the power socket.
Please note: The dishwasher will automatically continue on the programme it has started if the door is
opened or in the event of a power cut.
3
WC430 Manual.indd 4 3/6/09 11:19:03