Filter
Top Products
Airpot Coffee Brewers
SPECIFICATIONS AND OPERATION MANUAL
Electrical Specifications:
Model No. Volts Phase Hz. Watts Amps Receptacle
Nema No.
Circuit
Breaker
APT18 120 1 50/60 1.8 Kw 15 5-15R 15
APT18WT 120 1 50/60 1.8 Kw 15 5-15R 15
APT100WT 120/240 1 50/60 5.0 Kw 23 L14-30R 30
Line cord included. “WT” with Water Tap, “X” for export.
NOTES: APT100 Model includes twist lock plug wired for 4 wire 120/240V including Neutral and
Ground.
(120V Models – available on special order and requires a 15amp circuit breaker.)
Water Connections: ¼” flared water inlet fitting and flare nuts for ¼” O.D. copper tubing with a
minimum water pressure of 20 psi.
Dimensional Specifications:
MODEL Width (Inches) Depth (Inches) Height (Inches)
APT18 8 17 1/4 25 1/2
APT100 16 17 1/4 25 1/2
INSTALLATION AND START-UP INSTRUCTIONS
FOR AIRPOT BREWER
Not Included with this Brewer unless ordered separately
2.2 liter Airpot, Part No. V223A
Things to note when Brewing Coffee
• This brewer is set for 2.2 liter capacity Airpot.
• Volume can easily be adjusted for 1.9 liter or 2.5 liter Airpots.
WATER HOOK-UP
(Check Local Plumbing Codes)
The National Sanitation Foundation (NSF®) requires the following for an NSF approved hook-up:
1. A quick disconnect water connection or enough extra coiled tubing (at least 2x the depth of the unit)
so that it can be moved to clean underneath.
2. An approved back flow prevention device, such as a double check valve, must installed between
brewer and water supply.
Water Connection:
APT Brewers are supplied with 1/4” flared water inlet fittings and flare nuts.
Use a 1/4” diameter copper tubing to connect brewer to a cold water supply line with a minimum water
pressure of 20 psi.
HIGHLY RECOMMENDED: An external water supply shut-off valve near the brewer and a water purifier filter for
better tasting fresh brewed coffee.
2