Filter
Top Products
_______________________________________________________________________________________
insect
regulator hose-to-tank connection
are
heard
______________________________________________
insect
_______________________________________________________________________________________
insect
Burner Will Not Light
Burner Won't Stay Lit
Yellow Burner Flame
1) Lack of fuel
2) Burner venturi clogged with spider webs or
nest
3) Clogged or blocked orifices, burner ports, or
4) Igniter malfunction-
a. When rotating igniter knob no loud clicks
b. Igniter clicks but no spark in collector box
c. Collector box rusted out or damaged
5) Burner venturi misaligned on orifices
6) Crimped fuel supply hose
7) Bad regulator or damaged hose
_________________________________________
1) Lack of fuel
2) Too cold or windy
3) Burner venturi misaligned on orifices
4) Burner venturi clogged with spider webs or
nest
1) Burner venturi clogged with spider webs or
nest
2) Food particles, grease or seasonings on burner
3) Air in tank (before filling tank was not purged)
4) Burner venturi misaligned
Cause:
Cause:
Cause:
Corrective action:
Corrective action:
Corrective action:
1) For LP, be sure that the tank valve is
on 1 to 1-1/2 turns. For natural gas, be sure
the gas valve is turned on all the way.
2)
3) Clean with a straight pin or paper clip and
blow out
4) a. Be sure igniter knob is fully seated (snapped
into place) on stem and if still no clicks replace
both the igniter knob and igniter
b. & c. Check wire connections and if still no
spark replace collector box assembly
5) Position venturi over orifices properly
6) Straighten hose
7) Double check for proper and snug connections.
Replace if necessary
1) Fill cylinder
2) Rotate grill to where the front faces the wind
turn control knobs on high
3) Position venturi over orifices properly
4)
1)
2) Clean burner with safe solutions (see Cleaning
section in owner's manual for details)
turned
Clean inside venturi tubes with a small wire
brush or pipe cleaner
and
Clean inside venturi tubes with a small wire
brush or pipe cleaner
Clean inside venturi tubes with a small wire
brush or pipe cleaner
3) Use up LP tank (should improve with new tank)
4) Position venturi over orifices properly
33
Gas Grill Troubleshooting Guide
During the course of using your grill, you may occasionally encounter some cases where you have
questions as to how to keep your grill running properly. Following is a list of symptoms followed by the most
commonly used solutions.
Please, if you have a problem with your grill, and you are attempting to remedy it by yourself using the
following procedures, first read all warnings and safety precautions listed throughout the owner's manual.
For further assistance with operational and component issues, call our customer service center toll-free
in
the USA: 1-800-944-8982; in Canada: 1-800-668-5323
Comments: An unsuccessful ignition is often experienced when a gust of flames occurs due to the grill being
flooded with gas. This is a result of failure to follow the proper lighting instructions as explained in the owner's
manual. The gas is left on for over the allowed 3 to 5 seconds before ignition and finally it ignites. If the grill
fails to light with the igniter, use the match lighting instructions explained in the owner's manual.