Filter
Top Products
SKUs
40764, 93752,
For technical questions, please call 1-800-444-3353. Page 7
& 91905
Operation
1. Disengage the clutch by moving the Cam Ring (11) to the OUT position.
2. Grab the Cable Assembly (36) hook and pull the cable to the desired length, then attach
to item being pulled. Make certain that the hooks safety clasp is fully closed.
3. Reengage the clutch by moving the Cam Ring to the IN position.
4. Lift the Socket Cover (2s) exposing the electrical switch connector.
5. Insert the Switch Ass’y (35) connector into the Socket (6s).
6. While standing aside of the pull path, press (and hold) the Red switch on the Switch
Ass’y (35) forward.
Press (and hold) the switch backward to reverse directions. Wait until the motor stops
before reversing directions.
The power out function will puts stress on the winch’s automatic braking system.
IMPORTANT: Do not use the power out function of the winch for more than 10
seconds at a time; it may cause damage to the winch’s brake system.
7. When the pulling is complete, remove the Switch Assembly from the Socket (6s) and
replace the Socket Cover (2s).
CAUTION: The Electric Winch is designed for intermittent use only, and should not be
used in a constant duty application. The duration of the pulling job should be kept as
short as possible. If the Winch motor becomes very hot to the touch, stop the Winch
and let it cool down for several minutes. Never pull for more than one minute at or near
the rated load. Do not maintain power to the Winch if the motor stalls.
(6s)
REV 08h
WARNING!: You MUST leave at least ve full turns of cable on the drum
at all times. Review Winch Safety Warnings and Precautions starting on
page 3 before continuing. STOP THE WINCH IMMEDIATELY and release
cable with the switch if the cable begins to get entangled on the drum.