Citizen CT-S4000L Hot Beverage Maker User Manual


  Open as PDF
of 4
 
5.6 Printing Paper
Also refer to the core dimension and notes of “5.2 Printing Paper” in User’s Manual of
standard model. Use print paper shown in the following table or the equivalent.
Paper type Product name
Recommended thermal label paper GG40/P22/G6B from Ojitac, HD75 from Nippon Paper,
150LA-1 from Ricoh
a) Label paper
Full cut
position
Paper feeding
direction
Printable area
CAUTION!
Pay attention to the following when using Auto Cutter. Otherwise, a cutter lock or a cutter
failure may occur.
■ Set the cut length of paper to 25 mm or more.
■ When using label paper, cut the gap between labels (liner sheet). Do not cut the label paper
(tack paper).
■ Adusting the paper sensor must be carried when the type of liner is changed.
Mark Item Dimensions
A Liner width 58 to 112
B Label width 54 to 108 + 0.5
C Left edge of label 2 + 0.5
D Print width 50 to 104
ETop margin 2 + 1
F Print length 21 to 296
GBottom margin 2 + 1
H
Cut position between labels
1/2 x (Size I)
I Gap between labels 4 to 30
J Label length 25 to 300
K Label pitch I+J
Unit: mm
_
_
_
0
-1
In the case of memory switch 4-8 set to 0 (OFF)
Partial cut
position
Paper feeding
direction
Printable area
Mark Item Dimensions
A Liner width 58 to 112
B Label width 54 to 108 + 0.5
C Left edge of label 2 + 0.5
D Print width 50 to 104
ETop margin
12 - (I-2) +1, min2
F Print length 16 to 296
G Bottom margin 2 + 1
H
Cut position between labels
2 + 1
I Gap between labels 4 to 30
JLabel length 28 to 300
K Label pitch I+J
Unit: mm
_
_
_
0
-1
In the case of memory switch 4-8 set to 1 (ON)
_
 previous