Filter
Top Products
WIRING PRECAUTIONS
Read all wiring precautions. If you are not sure of the connections, contact your
authorized Clarion dealer.
1. Disconnect the negative (-) lead of the battery before making any power
connections.
2. When creating passage holes for the power wires, use grommets to eliminate
any sharp edges created during drilling. This will protect the wire from being
nicked and causing a short circuit.
3. When connecting the ground lead, fasten the ground lead (black) securely to
a clean metal plate on the vehicle.
NOTE: The VMA7191 monitor displays video images only. It does not provide
audio output. Refer to the owner's manual of the connected device for informa-
tion on audio output.
INSTALLATION
The VMA7191 is a 7" monitor with an Infrared (IR) eye. It will accept a video sig-
nal from any video source with composite video out. The IR eye will work direct-
ly with any Clarion video source product with an IR Eye Input.
1. Look over the vehicle for a location for the monitor. Each vehicle is different
and locations will vary. Make sure the monitor will not interfere with the
driver.
2. Once a location has been determined, connect the IR, Video RCAs and power
cables to the designated sources.
3. Feed the cables through the mounting location.
4. Plug the cable into the monitor's 8 Pin Din connector. Mount the monitor with
the provided hardware.
VMA7191
1 DC 12V
2 IR Out
3 Ground
4 Video Input 1
5 A/V Signal Ground
6 NC
7 Video Input 2
8 NC
8 Pin Mini DIN Connector
VIDEO IN
VIDEO IN
IR REMOTE OUT
GROUND
ACCESSORY