Filter
Top Products
PRODUCT VALVE
Replacing O-Rings
1.
Open product valve.
2.
Disconnect air hoses.
3.
Remove air cylinder.
4.
Remove valve tee.
5.
Remove all O-rings, grease and reinstall new
O-rings as required.
6.
Reinstall tee to kettle outlet.
7.
Reinstall air cylinder to bottom of tee.
8.
Reconnect air hoses.
9.
Close valve and check for alignment.
AIR HOSE
AIR
CYLINDER
AIR HOSE
OPEN
POSITION
CLOSED
POSTITION
0-RING
CLAMP
0-RING
VALVE
TEE
0-RING
CLAMP
KETTLE
OUTLET
KETTLE
HINGE ADJUSTMENT
INSTRUCTIONS
1. Insert 3/8" Allen wrench.
2. Turn clockwise to relieve tension on spring.
3. While tension is released remove one of the two
slotted screws.
4. To prevent Allen wrench from springing back
abruptly while the second slotted screw is
removed, insert a pin (approximately 1/8") in the
hole where the first slotted screw was removed
from.
5. Remove second slotted screw.
6. While holding Allen wrench remove pin.
7. Turn Allen wrench clockwise to tighten or
counter-clockwise to loosen tension to produce
desired effect.
8. Re-insert pin in one of the two holes.
9. Tighten one slotted screw in the other hole (it
may be necessary to turn Allen wrench slightly to
align holes).
10. Remove pin and repeat step number 9 for other
slotted screw.
3/8" Allen wrench
BUSHING REPLACEMENT
PROCEDURE
1. Remove agitator as per cleaning instructions.
2. Remove bushing by turning 1/4 turn and pulling
away from the kettle wall.
3. Lubricate metal surfaces with food safe grease.
4. Install new bushing by locating retaining pin and
sliding bushing on.
5. Rotate to lock into position.
6. Reassemble agitator.
OIL FILLING PROCEDURE
1. Disconnect air supply
and bleed system.
2. Remove cover on
console.
3. Check for oiler location.
4. Inspect oil level in bowl.
5. Remove filler cap.
6. Add mineral oil as
required.
7. Replace filler cap and
console cover.
Filler
Cap
Bowl