Filter
Top Products
View Machine Info HotCup Operators’ Guide
6740001 88 November, 2007
DBV COMM
Incomplete bill validator communications — check harness.
DBV MOTOR
One of the motors has failed. The unit will disable itself until the error is
corrected. Check for bill stuck in the acceptance path. If no bill is present,
replace the validator. Cycle machine power OFF and then ON.
DBV SENSOR
One of the sensors in the bill validator has failed. The unit will disable itself
until the error is corrected. Check for bill stuck in the acceptance path. If no
bill is present, replace the validator. Cycle machine power OFF and then
ON.
DBV JAM
A bill is jammed in the acceptance path. The unit will disable itself until the
error is corrected. Remove bill stuck in the acceptance path. Cycle
machine power OFF and then ON.
DBV STACKR
The stacker is open or removed. The unit will disable itself until the error is
corrected. Install the stacker correctly.
CHK PRICE
Price error detected and changed to maximum - check prices.
NONE READY
All selections are reported out of service.
pV.ERR CUP 1
Cup ring 1 is out of service due to a PosiVend™ error.
pV.ERR CUP 2
Cup ring 2 is out of service due to a PosiVend™ error.
pV.ERR PCB
PosiVend™ is ON but not working. The last calibration sample was 255.
Check that the PosiVend™ PCB is present at J34.
PV.ERR SNSR
PosiVend™ is ON but not working. The last calibration sample was £50.
Check for a blocked sensor or disconnected harness.
AJP.TMR1 XX
PosiVend™ is active and ring 1 anti-jackpot timer is ON. XX is a value
between 1 and 99 in minutes.
JP.TMR2 XX
PosiVend™ is active and ring 2 anti-jackpot timer is ON. XX is a value
between 1 and 99 in minutes, and represents the amount of time left on the
anti-jackpot timer for this cup ring.
ANo brewer
Brewer is missing or malfunctioning.
Brewer.err
The brewer is in an incorrect position.
Brewer jam
The brewer has not reached an appropriate position within a certain time-
out period. Check for a physical jam or a motor stall condition.
Reset brwr
The brewer is clamped and not vending, or is not in a brewer test mode.
Close the door (if open), or run a brew test.