Filter
Top Products
Español-10
Lista de piezas
Encendido estándar
No. 428 Descripción
1 220C1401 Tapa de combustible
2 220A6201 Juego de reparación de la bomba
3 414-6601 Válvula y generador
4 414-5621 Generador
5 413D3461 Quemador auxiliar
6 R413-149T Perilla de la válvula
7 425A3451 Quemador principal
8 426A5281 Conjunto del colector
9 426-3141 Rejilla
10 414-5601 Ensamblaje del Tanque
11 639-1091 Taza de bomba y presilla
12 413B4971
Presillas de los de ectores de viento
13 N/A Conjunto de encendido
14 N/A Perilla de encendido
15 200-6381 Ensamblaje de válvula de retención y tubo
VEA EL DETALLE “A”
VEA EL DETALLE “A”
English-4
■ Place tank on level surface resting at
angle shown. (Fig. 2)
Leak Check
Fig. 2
■ Remove FUEL CAP. Use a funnel or
suitable lling device and ll with
clean, fresh fuel.
■ Replace FUEL CAP on tank and
on fuel container. Tighten rmly.
WIPE UP ANY SPILLED FUEL AND
DISPOSE OF IN A SAFE PLACE.
Fig. 3
Pumping
■ Be sure FUEL VALVE is OFF
(Fig. 4) and FUEL CAP is rmly
closed (Fig. 5).
Fig. 4
Fig. 5
■ Place thumb over hole in pump knob
and pump approximately 30 full
strokes. (Fig. 7)
■ Close PUMP KNOB. (Fig. 8)
Fig. 7
Fig. 8
■ Make sure FUEL VALVE is fully
“OFF”.
■ CHECK FOR LEAKS in one or more
ways. Look for fuel mist or a wet
appearance of fuel on surfaces.
Listen for hiss of escaping gas. Smell
for fuel odor. Never use a ame. Do
not use if leaking. (Fig. 9)
■ Open PUMP KNOB one full turn.
(Fig. 6)
Fig. 6
Fig. 9
CHECK
FOR
LEAKS
CHECK
FOR
LEAKS
CHECK
FOR
LEAKS