Filter
Top Products
7.
Observe the flame from below the rotisserie.
8.
Flame should be blue with a hint of yellow
on tips.
English-10
INSTASTART™ Electronic
Ignition Rotisserie:
1. Open the lid.
2. Make sure all valves are OFF.
3. Turn on the cylinder valve.
4. Push in and turn on the Rotisserie Control
Knob counterclockwise to HIGH, then
repeatedly press the igniter switch until the
flame ignites (Fig 19).
5. If ignition does not occur in 5 seconds, turn
the Rotisserie Control Knob off, wait 5
minutes, and repeat the lighting procedure.
6. If the burner does not light after trying
again, turn off Rotisserie Control Knob and
try match lighting the burner.
HINT: If the igniter fails to light the rotisserie
burner, adjust electrode tip with needle-
nose pliers. A spark must jump near a gas
opening in the burner when igniter is
activated. Use care not to damage the
ceramic insulator on electrode.
Fig. 19
Push
Repeatedly
Rotisserie Burner
Lighting
(cont.)
9.
Adjust flame with the control knob (Fig. 20).
MMaattcchh LLiigghhttiinngg::
CAUTION
Use a LONG wooden match or a butane
lighter with an extension. Make sure all
burner controls are off except for the
burner being lighted. If a long-reach
match or lighter is not accessible, use the
match extension. The match extension is
located inside the doors. Insert a match in
the holder end of the extension, strike and
place the burning match near the
BURNER being operated.
1. Open the lid.
2. Make sure all valves are OFF.
3. Turn on the cylinder valve.
4. Strike and place the burning match
near the rotisserie burner, then push
in and turn on the Rotisserie Control Knob
counterclockwise to HIGH (Fig. 21).
Fig. 20
Fig. 21
5. Adjust flame with the control knob (Fig. 22).
Fig. 22