Continental Platinum CP42149 Blender User Manual


  Open as PDF
of 4
 
CLEANING
Quick cleaning:
Assemble the blender jar and pour lukewarm water and some
washing-up liquid in tho the blender jar.
Assemble the lid and the stopper.
Let the appliance run for a few moments by pressing the Quick Clean button, then
release this appliance.
Remove the blender jar and rinse it with clean water.
Thorough cleaning:
Remove the blade unit and clean all parts separately. Be careful
with the sharp edges of the blade unit.
CAUTION
1. The plug must be removed before cleaning the blender and it must be dried before
the blender is used again.
2. Do not use the blender if the lead is damaged.
3. If the power cable on the blender is damaged, it may only be replaced by a repair
center recognized by the manufacturer, since special tools are required.
4. The blender must not be immersed in eater for cleaning purposes.
5. Do not use the blender for purposes other than that for which it is intended.
6. To ensure continued protection against risk of electric shock, connect to properly
grounded outlets only.
NOTE
1. Caution: mixing at most 60 seconds must stop and wait 60 seconds before
resetting.
2. If the power cable is damaged, it must be replaced by it’s manufacturer or
manufacture’s after-sales service or an equally qualied person in order to avoid
danger.
3. 1)A short(or detachable)power supply cord is to be provided to reduce risks resulting
from becoming entangled in or tripping over a longer cord.
2)Longer extension cords are available and may be used if care is exercised in
their use.
4. The marked electrical rating of the extension cord should be at least as great as the
electrical rating of the appliance.
5. If the appliance is of the grounded type, the extension cord should be a grounding
type 3-wire.
6. The linger cord should be arranged so that it will not drape over the countertop or
tabletop where it can be pulled on by children or tripped over.
Para apagar el motor, presione el botón “O”.
Limpieza
Limpieza rápida:
Arme el vaso vierta agua tibia y un poco de líquido lavavajillas dentro del vaso.
Coloque la tapa y el tapón.
Haga funcionar el aparato durante unos mementos presionando el botón de
Limpieza Rápida. Luego suelte el botón.
Retire el vaso y enjuáguelo con agua.
Limpieza profunda:
Retire el aditamento de la cuchilla y lave todas las piezas por separado. Tenga
cuidado con los bordes alados de la cuchilla.
PRECAUCIONES
El enchufe debe permanecer siempre seco.
No utilice la batidora si algún componente está dañado.
Si el cable está dañado, solo podrá ser reemplazado por un técnico calicado.
Nunca sumerja el aparato en agua u otro líquido.
No utilice este aparato de una forma que no sea la recomendada en este manual,
ni para ninguna función que no se especique en estas instrucciones
Para prevenir el shock eléctrico, conecte siempre el aparato a un enchufe con
toma de tierra.
Observaciones
Como medida de seguridad, el cable del aparato es corto, evitando el riesgo de
tropiezos.
El voltaje de la red debe corresponderse con el voltaje que gura en el aparato.
 previous