Continental Platinum 3
Continental Platinum 3
A short power-supply cord is provided to reduce the hazards result-
ing from entanglement or tripping over a longer cord. An exten-
sion cord may be used with care; however, the marked electrical
rating should not be at least as great as the electrical rating of this
appliance. The extension cord should not be allowed to drape over
the counter or tabletop where it can be pulled on by children or
tripped over.
Polarized Plug
This appliance has a polarized plug (one blade is
wider than the other), as a safety feature, this plug will t in a
polarized outlet only one way. If the plug does not t fully in the
outlet, reverse the plug. If it still does not t, contact a qualied
electrician. Do not attempt to defeat this safety feature.
How to make toasted sandwiches
1. When using the rst time, wipe the surface of the platens
with a damp cloth and dry with cloth , tissue etc. Then smear the
platen with butter, margarine or cooking fat.
2. Fit the plug into the wall socket.
3. Close the Sandwich Maker and prepare sandwich while
toaster is heating.
4. When the Sandwich Maker is ready after about 5 mins., the
ready to cook light will come on (or light will be off if the toaster
has only one light).
5. Fully open the Sandwich Maker. Place a slice of bread in
the bottom half with the buttered side against the platen.
6. Fill the sandwich, pressing the bottom half into the platen.
7. Place on the top slice with the buttered side up and care-
fully close the two parts of the toaster together. Do not force shut.
Steam will be ejected from between the platens while doing this
and care must be taken to ensure that ngers do not come into con-
tact with same.
LIMPIEZA
• Después de usarlo y antes de limpiarlo retire el enchufe y
espere a que se enfríe.
• Limpie el interior y los bordes con papel absorvente o paño
suave.
• Si quedan restos diciles de remover, vierta un poco de
aceite de cocina sobre la placa y vuelva a limpiar después de 5
minutos.
• Limpie el exterior únicamente con un paño apenas húmedo
asegurándose que no entre agua, aceite o grasa por las ranuras de
ventilación.
• Nunca use limpiadores abrasivos o esponja de metal.
• No lo sumerja en agua u otro líquido.