Creda CM 311 I Freezer User Manual


 
Installation (Door reversal).
6
If you find that the direction of the door
opening is not convenient,you can reverse it.
The necessary holes on the opposite side of
the cabinet have been made inthe factory and
plugged.
* Remove the top hinge cover of the
refrigerator door.Remove the door by
unscrewing the hinge (the door is
supported only by the bottom hinge) and
remove the hinge washer.
* Unscrew the top strip,move it on the
opposite side of the appliance and fasten
it.
* Unscrew the bottom hinge and washer of
the freezer door and the bottom hinge of
the refrigerator door.
* Remove the corner caps from the door and
reposition them (instead of the one with a
hole insert the one without it,and vice
versa).
* Take off the washer from the bottom hinge
of the freezer door (by turning it in
clockwise),unscrew the bottom hinge
filling plug and screw the bottom hinge
without a plug.
* Insert the filling plug and washer in the
reverse order into the ho;e for the bottom
hinge on the opposite side of the
appliance.
* Put the freezer door on the bottom hinge.
* Turn the bottom hinge of the refrigerator
door by 180˚,insert the hinge and the
washer into the hole of the corner cap on
the freezer door and fasten it.Use the same
procedure for the top hinge of the freezer
door and screw it on the opposite side of
the upper door.Put the washer and the
upper door on the hinge.
* Screw the top hinge of the refrigerator
door and replcae the cover.
* Reposition the slide guides on the
opposite side of both doors.
* Plug the remaining holes with the
decorative caps.
* After you have reversed the door,check if
the magnetic gasket seals correctly.It must
not be creased and must seal all around
the door.
694527.qxd 1/31/03 9:18 Page 6