Filter
Top Products
7
D
ISHWASHER
First of all.
- Turn on the water supply tap
completely.
- Add the correct amount of
detergent.
- Load the baskets correctly.
- Check that the spray arms rotate
freely.
- Close the door securely.
-
Press the ON-OFF button "A": indica-
tor light "B" comes on. Your appliance is
now on and ready to be programmed.
Select the wash cycle.
To select the wash cycle, turn knob "D"
clockwise until the indicator on the knob
lines up with the number or symbol for
the wash cycle most suitable for the type
of dishes to wash (see ‘Programme
Chart’).
After a few seconds, you will hear a short
beep: the wash cycle has started, it is
not advisable to make any changes from
this point.
Indicator lights
Your dishwasher is fitted with indica-
tor lights (E) that come on to show you
at which point the wash cycle is at.
Here are the symbols corresponding
to each cycle phase:
Starting from the indicator light on the
left moving towards the one on the
right: pre-wash, wash, rinses, drying.
At all times, your dishwasher tells you
where it is at.
Modifying a wash cycle in
progress.
If you have chosen the wrong cycle - You
can modify the wash cycle in progress,
if it has only just started. Turn knob "D"
anti-clockwise and set it to Reset, after
a few seconds you will hear 3 short
beeps and
Indicator light "E" will go out to show all
the settings will have been cancelled. You
are now free to re-set the correct wash
cycle.
You've left out a dish?
Interrupt the wash cycle by pressing the
ON-OFF button, insert the dish you had
forgotten and press the ON-OFF button
again.
The cycle will start up from where you
interrupted it.
Cycle end
The end of the wash cycle is indicated
by 2 short beeps and a flashing drying
phase indicator light .
Set the knob to the reset position to clear
all settings.
Turn the appliance off by pressing but-
ton “A”, cutting off the electricity supply.
Turn off the water tap.
Wait a few minutes before unloading the
dishes: they are very hot! If you wait a
little while, they dry better due to the
steam.
Empty the lower basket first.
There's been a power failure or
you opened the dishwasher
door
The wash cycle stops and then restarts
when the electricity comes back on or
when you close the door.
How to use your Dishwasher